Electronics Forum | Wed Jul 12 16:17:33 EDT 2006 | nodlac
FYI Here is the SMEMA Link for the generic interface configuration. http://www.smema.org/smemastandards.htm and http://www.smema.org/smema1.2.pdf These Doc should give you the SMEMA pin outs. Cal
Electronics Forum | Tue Jul 11 03:32:16 EDT 2000 | Charles Stringer
Can anybody advise where I can get the full SMEMA interface specification. I need to move about an old line and interface to Siemens Siplace which I understand is not true Smema - I have a spec for the Siplace interface - I now just need one for Smem
Electronics Forum | Tue Jul 11 10:40:10 EDT 2000 | John Thorup
Charles Have you tried the SMEMA (now part of IPC)web page (www.smema.org)? Interface Standard 1.2 is available in PDF. John Thorup
Electronics Forum | Wed Nov 29 10:48:37 EST 2006 | bas Rottier
Hello, I'm looking for a protocol description of the SMPI interface (we would like to connect a SMPI machine to a SMEMA machine). Does anybody have description of signals (electrically) + waveforms + pin-layout + connectortype? THanks Regards bas.r
Electronics Forum | Wed Nov 29 20:35:47 EST 2006 | davef
Fine SMTnet Archives are amazing. Look here: http://www.smtnet.com/Forums/index.cfm/fuseaction/view_thread/CFApp/1/Thread_ID/6759
Electronics Forum | Fri Oct 23 15:15:51 EDT 1998 | Dave f
| I am looking for detailed information on the SECS 2 protocol that is part of the SEMI General Equipment Module interface. I was not able to get detailed information from the SEMI web site and was not able to find anything on the web. | | I am look
Electronics Forum | Thu Dec 03 14:45:16 EST 2015 | ttheis
Thanks. Our older oven does have a basic PC interface but no SMEMA. Maybe I can write a short program for the oven's PC to pace the boards into the oven. I could interact with the conveyor's SMEMA interface via low-cost Arduino or something similar.
Electronics Forum | Sat Nov 07 22:00:29 EST 2015 | ttheis
I've seen a few used machinery companies using manual smema interface boxes with a few buttons on them to simulate upline and downline equipment but I haven't found anyone selling them or info on them. Does anyone know where they can be bought or if
Electronics Forum | Thu Dec 03 14:40:27 EST 2015 | proceng1
When we had a line that ended at an older reflow oven without SMEMA controls, I ran a momentary switch to the two pins in the connector. I push the button and the conveyor pushed the board onto the edge-hold of the oven. As a joke I labelled it "LA
