Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Wed Nov 17 15:04:27 EST 2004 | russ
SMT assembly, First, you must utilize paste otherwise the parts will not stay put. Do you have any leaded devices such as QFPs or SOICs? Dispensing paste by hand is very difficult and time consuming for these types of parts. You can either dispense
Electronics Forum | Wed Aug 18 21:10:23 EDT 1999 | se
| | | Hi, | | | I'd like to ask some tips about the merits and shortcomings o | | | of both screen printer and stencil printer. For small quantity and highly mixed usage, which type of printer is suitable to our | | | application? | | | The board
Electronics Forum | Wed Nov 17 09:51:25 EST 2004 | AS
I'm looking for advise on setting up a prototype station for smt (we are currently outsourcing smt production, but have a need for rapid in house prototyping). The station must be able to handle only single sided boards with components no smaller th
Electronics Forum | Tue Feb 10 17:38:22 EST 2015 | mbartel
low volume high mix, looking for advice on what i should get, a stencil machine or a jet printer for smt solder paste. used/new and companies i should look into?
Electronics Forum | Wed Feb 11 10:57:48 EST 2015 | mbartel
I do a lot of prototyping, but I also do production boards. I produce 2000-5000 boards a month for an in house smt process. I feel this will increase do to the fact that our engineers are designing more with surface mount rather than through hole. S
Electronics Forum | Fri Nov 07 23:40:41 EST 2008 | padawanlinuxero
I have been working on the SMT area for a while now, must of my experience is on programming and pick and place, now in my new job I have to control a complete SMT line and I have a little knowledge on working with solder paste but I like to read mor
Electronics Forum | Mon Apr 26 08:15:37 EDT 2004 | pjc
MPM uses a one-print-Mylar system, as do other printer mfrs. In this system there is a Mylar sheet attached to a frame that is secured over the printer table with the board on it. You print onto the Mylar. The table X-Y-theta manual adjustments are u
Electronics Forum | Mon Dec 22 12:14:15 EST 2008 | pcbbuilders
we sometimes have problems with solder paste release. we use a manual stencil printer. does anyone have any thoughts on using two passes of solder paste on the stencil? i have found that running the second pass gives me better deposits on the fine pi
Electronics Forum | Mon May 18 10:54:46 EDT 1998 | Jerry
If it's really low volume I would only invest in a stencil printer and convection reflow oven to start with. If you want to go really low budget get a manual unit such at one from Transition Automation. Make up some really good shop aids and have s
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
3 Road Xintang, Fuhai Street,Fuyong
Shenzhen, 30 China
Phone: 13713862102