Electronics Forum | Thu Mar 01 10:46:11 EST 2001 | davef
Various lint free stencil wipe suppliers take various approaches to stencil cleaning. For instance ... Techspray Directions: Start with a dry TechClean Wipe (2358, 2361, or 2362) to remove excess solder pastes. Follow this with the 1608 Pre-Saturat
Electronics Forum | Wed Oct 31 03:35:41 EDT 2007 | meritajs
Hello All, We have problem with one from our YAMAHA SMT mounter. It had weard defect. It gives error message"soft limit X over" when next step must pick up with head3. But all coordinat for next component do not exeed movable range. This failure happ
Electronics Forum | Mon Oct 25 14:48:29 EDT 1999 | William
All, I am having a problem with joints being soft after SMT. Especially 25 mil and smaller parts. It seems as though you can slide the leads right off of the solder. It takes only about 30-40 oz. of compression at 45 deg. to move leads off of join
Electronics Forum | Tue Mar 09 22:47:26 EST 2004 | pdeuel
Contact sensors out of adjustment. If you push up on spindle the led should change state. same if spindle is pulled down. I have also had problems with PTIF error during zeroing Soft stop. last messages recieved were reported as z axis time out durin
Electronics Forum | Fri Apr 15 07:53:40 EDT 2005 | mmjm_1099
For DEK supports heres a link for soft supports. http://www.dek.com/web.nsf/dek/formflex
Electronics Forum | Tue Mar 31 19:50:22 EDT 2009 | davef
8 bar is over 100 psi. What are you using that much pressure? So, your piping is made of what material? * Black iron * Copper Can you run soft pressure piping to by-pass the section that requires sealing?
Electronics Forum | Mon May 24 13:06:12 EDT 1999 | Deon Nungaray
| | | Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcohol, blowing them o
Electronics Forum | Wed May 26 15:02:40 EDT 1999 | Paul Bonstrom (SGI)
Looking for help in finding suitable high temp gasket for use in smt assy support application. Gasket used to restrain flex on smt module in area prone to localized heating due to nearby device removal (hot air). Current gasket mtl (neoprene) degra
Electronics Forum | Wed May 26 16:36:02 EDT 1999 | John Thorup
| Looking for help in finding suitable high temp gasket for | use in smt assy support application. | | Gasket used to restrain flex on smt module in area prone | to localized heating due to nearby device removal (hot air). | | Current gasket mtl (n
Electronics Forum | Thu Jun 06 07:53:51 EDT 2002 | Jim M.
Has anyone had much luck Picking and Placing die with a Panasonic MPA-G3?What special setups or considerations are required? Currently we pick and place one die with our Universal GSM using only one nozzle. The nozzle must be painted white in order
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694
