Electronics Forum | Tue Oct 17 12:07:58 EDT 2006 | pms
ya don't need no stinkin pads. just run sum fine gauge insulated jumpah wires from da I.C. legs (da ones with da missin pads) to da traces or where-ever dem traces end up. dat should get er dun !!!!
Electronics Forum | Fri Mar 26 17:12:17 EST 2004 | ben
I have recently encountered a new pcb design with a very high density of components on either side of the pcb. One of the suggested "fixes" is to use the smt pads as vias i.e. the via will be drilled thorough the centre of the smt pad. My concern i
Electronics Forum | Sat Mar 27 08:15:02 EST 2004 | davef
Via in pad is a designer's dream and an assembler's nightmare. Search the fine SMTnet Archives for previous discussions to get started. VIP, via-in-pad, or whatever tend to promote voiding within the via and certainly partially starved solder conne
Electronics Forum | Wed Oct 18 07:51:14 EDT 2006 | davef
Look here: http://www.circuittechctr.com/ As a low cost approach, use copper foil purchased from a stained glass window hobbyist shop. Cut foil pieces to size with a sharp knife. Epoxy the pieces in place of the damaged pads. Tin and then solder th
Electronics Forum | Sat Apr 03 05:21:33 EST 2004 | mattkehoe
There is a method for VIP you may not be familiar with. I dont want to go into depth here but check out http://www.sipad.com/sipadvip.htm and contact me off line if you want more info. Good luck. mk
Electronics Forum | Mon Oct 16 17:46:49 EDT 2006 | Dan
Recently I was given a bad Bios Link from Toshiba which fried my Bios and now my laptop boots to a black screen. I recently unsoldered and removed the existing Bios chip and have ordered anotherfor replacement. Unfortunately while removing, i damag
Electronics Forum | Sun Mar 24 16:53:44 EST 2002 | mikestringer
We place a similar square pin style of connector on one of our products. The connector is a 22mm high HW series from Samtek. We have a Yamaha YVL88 MK1 and YV88XS set up to handle them (Yes they are rebadged as Philips machines in some markets). No
Electronics Forum | Fri May 14 16:49:17 EDT 2021 | winston_one
Agree with WiIIR and also can recommend to play with vaccum pump RPM . Slower vacuum increasing have help me to resolve one problem caused by the vacuum (it was solder splash from BGA balls, but the reason can be similar to your case). Also check i
Electronics Forum | Fri May 06 06:51:55 EDT 2016 | abhilash4788
Hi All, One of my customer has provided a pcb design having common pad for 0402 and 1206 package(i.e 3 pads in the gerber, pad1,pad2 belongs to 1206 package and pad2,pad3 belongs to 0402 package) Will this create any solderability issue. Is anyone e
Electronics Forum | Fri May 06 08:39:59 EDT 2016 | kahrpr
The first issue I see is that you have a high potential of the 402 tombstoning.
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694