Electronics Forum | Wed Jun 12 14:05:40 EDT 2019 | proceng1
Good deal. I've had this issue many times and the magnetic switches almost always fixed it.
Electronics Forum | Tue May 07 08:35:43 EDT 2019 | paulanderson
I Have a SMTech/Quad MV100 Printer and it powers up and system on activates but does not go through home sequence - any ideas? All axis will move in the diagnostic mode
Electronics Forum | Wed May 08 06:43:07 EDT 2019 | paulanderson
I have also reset and checked all the inputs are working and all seem OK. Would be grateful if some one could confirm the home sequence, so I can at least start looking there first Thanks in advance
Electronics Forum | Wed May 08 09:17:51 EDT 2019 | bobpan
push the 2 left buttons on the membrane panel after releasing the e-stop....this should get you into diagnostics....you then need to reset the system parameters. It may home then. good luck, Bob
Electronics Forum | Wed May 08 09:23:34 EDT 2019 | paulanderson
Hi Bob, I already tried this :( Do you know the home sequence, as Im thinking it may be waiting for the first item to complete? Paul
Electronics Forum | Mon May 20 06:40:39 EDT 2019 | paulanderson
Thanks - This is exactly what it was. Separately I was isolating each of the safety circuits on the main board and that confirmed it was the top lid magnetic switch was faulty. It was the only one not shown as an input in the diagnostic page :(
Electronics Forum | Sun Jul 14 09:10:41 EDT 2019 | dilogic
Does anybody have it? Our printer started to act strange lately. I have user manual, but that's not enough to do the necessary troubleshooting. By the way, I really hate the way it is constructed - you need a pit to access main board. What were they
Electronics Forum | Wed May 08 12:01:49 EDT 2019 | bobpan
pretty sure it does squeegie blades first....then if you have a table...it drops and starts to move out.....and then the head moves. Most times i have seen this....if nothing is moving....one of the cover switches are not made...use a magnet on each
| 1 |
.gif)
