Electronics Forum | Fri Jun 30 20:39:52 EDT 2006 | johnwnz
Grant, Haven't doen any work with the SN100C paste, the problem I guess is yoru subject to the suppliers flux base so if that is poor then the alloy may not perform as well as it could. We've found Avantec to be pretty good at SMT but have got SN100C
Electronics Forum | Wed Feb 20 13:49:54 EST 2013 | tkotwal
I'm looking for a preheater for hand soldering, but haven't used one before so I could use some advice. Does anyone have any preferred styles or brands? Is there anything in particular that I should either look for or should avoid? I've seen prices r
Electronics Forum | Fri Feb 22 15:23:54 EST 2013 | tkotwal
Thank you for the advice. I have the same concerns with applying that much heat from a single point, so I will probably go with a Zephyrtronics preheater. Tom
Electronics Forum | Thu Feb 21 12:49:07 EST 2013 | deanm
We had the same problem with one of our boards with ground planes so that it required preheat using a hotplate before hand soldering. Then I learned about the Metcal MX-5000 series soldering irons. I was skeptical at first but we can now solder the s
Electronics Forum | Wed Feb 20 15:20:34 EST 2013 | hegemon
Depending on your requirements, you could range from a hair dryer, heat gun, toaster oven, hot plate, on up to digitally controlled surfaces and convective systems. You'll have to gauge for yourself whether you are just trying to add some heat energy
Electronics Forum | Thu Feb 21 14:40:42 EST 2013 | hegemon
My own preference in this arena is towards the forced air convection style preheat, the key being the forced air. Radiant preheat is too slow for some, and IR preheat can have other issues that convection (or radiant) will not. Zephyrtronics has bee
Electronics Forum | Thu Feb 21 09:30:05 EST 2013 | tkotwal
Thank you for the advice Hegemon. I agree that there is a wide range of options available. I'm looking for something that can give me some repeatable surface temp control, is easy to work with, and has at least decent build quality. I don't necessari
Electronics Forum | Tue Jun 27 10:30:54 EDT 2006 | russ
Aj, Did you switch from SN100C to the SACX? Russ
Electronics Forum | Thu Jun 08 16:03:52 EDT 2006 | jbrower
On Saturday the 3rd, I offloaded nearly 1200 pounds of solder from my Electrovert, did the tin purge and loaded nearly 1200 pounds of sn100c back into my solder pot. It was a hell of a job, but we got it done in 8 hours. We've been running with this
Electronics Forum | Mon Jun 12 07:27:19 EDT 2006 | amol_kane
thanks Jay,