Electronics Forum | Tue Mar 06 13:39:49 EST 2018 | GTune
Hello everyone, I am having trouble with our UIC VCD through-hole pick and place machines. It has been sitting around for several years now and I had to replace half the gaskets in the machine which werecausing slow movement. I'm getting an error mes
Electronics Forum | Mon Feb 19 18:57:49 EST 2001 | davef
Expanding on the limit of the portion of gold acceptable in a solder connection [mentioned in an earlier post]: The embrittlement culprit, AuSn4, is 29 weight percent gold. So even if one had 100% tin as the solder alloy and 10% gold were dissolved
Electronics Forum | Tue Sep 26 10:22:51 EDT 2006 | SWAG
Histogram: Place standard tooling block in centernest. Jog camera over block. Jog z-axis to soft limit. Place a white card under camera. User mode to test. Turn board lamp on. From test menu, select histogram. With board lamp on and white under camer
Electronics Forum | Sun Feb 04 15:06:20 EST 2007 | Scotty
Profile should have a longer cool soak. Verify as was mentioned all pin/fixture support through out the entire process. Print, Place, pre reflow hand load, post reflow, carriers, ICT, Depanel and FCT. Conformal Coated or Potted? Mylars work well for
Electronics Forum | Fri Jan 21 00:11:50 EST 2011 | jeffr
Yes you must select FixedTrayFeeder. You must select TEACHING not AUTOSET. The trap is... you must select a TEACHING UNIT prior to doing the teaching (CAMERA-HEAD1-HEAD2)are the choices. Press F8 to get this menu to appear. If the camera cannot reac
Electronics Forum | Wed Dec 14 15:49:30 EST 2005 | derengmao
I did calibration for the fixed camera according to the Training Center System's book. But it seemed it is for diciding the heads'offset, very few is for camera itself. When calibrate, It does recognize the calibration tool ad finish. However when te
Electronics Forum | Tue Aug 19 14:24:22 EDT 2008 | shanenaturalpoint
My first problem is that when the unit homes, the print carriage seems to be traveling too far back. After the carriage reaches its mechanical limit, it continues to try and move back, eventually throwing up a print carriage error. Any ideas?
Electronics Forum | Thu Sep 04 02:43:09 EDT 2008 | benefon
Thanks This error only occurred with one oven profile with the reflow zone temperature set at 270�C. Perhaps it really has to do with the exhaust pull as the oven is operating very near its temperature limit with this profile. I will check that. Tha
Electronics Forum | Tue Mar 12 07:46:26 EDT 2013 | ngineer
bobpan, It only happens with this program. CC ver 7.54, IVC V 3.05 If i leave CC out of it, and edit the sequence using the HHT, it sticks. but if i download from the assembler to CC, it's messed up. if i then fix it in CC, the minute i save
Electronics Forum | Mon Mar 25 14:59:55 EDT 2013 | jimmyboz
Yes, he is correct, it is probably a sensor. That does NOT mean a sensor is bad, just that it has not been activated during a time limit or servo count. Watch what the last 2 or 3 things it does before the error.
.png)
