Electronics Forum | Tue Nov 19 12:36:01 EST 2013 | youngbuck
DEK Infinity-Does anyone have any information on why the automatic screen changer would load the same screen in a different position everytime you load and unload? We constantly have to do a search step for the fiducial and most of the time it will e
Electronics Forum | Fri Apr 29 15:17:54 EDT 2022 | glasscake
If the machine was working appropriately before the hard drive failure i would lean on the issue being a configuration issue. Lots of machines have options in their software for different sized motors, limit sensors, IO configs, ext. See if you cant
Electronics Forum | Sat Jan 21 10:28:16 EST 2023 | compit
The so-called "drivers" are used to control each servo - control boards at the back of the machine. There are several (8?). If one is "worn out" and has no strength to move the servo, maybe this is where the error comes from? They can be interchanged
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Fri Jun 04 09:20:55 EDT 1999 | HST-SE
Al, We make stencils, and I was personally involved at AMTX when the electroformed process was developed. Some of this will sound like an ad, but everyone has been volunteering vendors and so look at this as a suggestion. Electroforming is an addit
Electronics Forum | Tue Nov 29 08:32:08 EST 2005 | stefwitt
Particular as a small company and limited resources you�ll be requiring a lot of assistance from the machine vendor. Did you check which other machines are used in your area and if there is already a local service tech? Did you get in contact with o
Electronics Forum | Fri Jul 09 17:52:43 EDT 2021 | glasscake
Hello, I have a Topaz-X that is losing its R origin as it runs. The issue can be seen in the following test: Set the machine to ignore vacuum/ignore alignment and have no feeders in the machine also set the nozzles all to fixed. I run a servo orig
Electronics Forum | Sun Aug 08 20:59:55 EDT 1999 | Dreamsniper
| | | What oven temperature should be used to reflow solder (Sn63Pb37) on a PC board (0.075" to 0.100" thickness) in 5 to 10 minutes? | | | | Profiling - tedious but important. As said, start with the paste manufacturers recomendation which is usua
Electronics Forum | Mon Jul 26 10:44:08 EDT 1999 | Boca
| There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing
Electronics Forum | Tue Mar 29 04:15:01 EDT 2011 | ravo
Dear All, Thank you so much for your cooperation. Actually am in continous problems with my BGA and can not assemble it using my QP242 till now, I am using the following data : Vision no. : 1 Vision Type: 230 Height: 2.32 Body Size X: 27.00 +-0.