Electronics Forum | Thu Aug 24 14:42:30 EDT 2006 | any
y we had solder ball after reflow owen?
Electronics Forum | Thu Feb 08 09:07:22 EST 2001 | Hussman
OK, without knowing the specifics, why does everyone blame the oven? Most solder balls occur around R's and C's in almost every shop I've been to. The best place to start looking is the screen printer - not the oven. Sure the oven is the last proc
Electronics Forum | Thu Aug 24 15:37:50 EDT 2006 | Chunks
Hi Any, This is from an earlies thread "Solder Ball After Reflow Process". Date: August 16, 2006 01:52 PM Author: Russ Subject: Solder Ball After Reflow Process Oven settings are meaningless here. What does the board see? It is the paste we a
Electronics Forum | Fri Oct 24 06:55:48 EDT 2008 | clampron
Good Morning WS, If you experieced the solder balls after reflow of a bare board through the oven, then the source of the solder is either the oven or the board. I have had boards with untented via's that were HASL'd that had entrapped solder and fl
Electronics Forum | Tue Feb 29 10:14:02 EST 2000 | Robert Hartmann
My company is just getting into the flip chip packaging arena. We are putting in a prototype/small volume wire bond PBGA line. We have some questions with regard to choosing solder balls and cleaning of flux. 1) Is there a formula for the shrink
Electronics Forum | Tue Feb 29 10:14:02 EST 2000 | Robert Hartmann
My company is just getting into the flip chip packaging arena. We are putting in a prototype/small volume wire bond PBGA line. We have some questions with regard to choosing solder balls and cleaning of flux. 1) Is there a formula for the shrink
Electronics Forum | Tue Jul 06 10:46:12 EDT 2004 | blnorman
We have now switched to Kester EP256. During our solder paste evaluation, resistance to humidity was one of the selection criteria. We printed multiple boards, then exposed them to 85�F/65% RH. At 30 minutes, 1 hour, 2 hours, and 4 hours exposure
Electronics Forum | Wed Feb 07 16:14:54 EST 2001 | Antonio
I've recently read a posting here which said that the person was trying to reduce solder balls. One of the things the person had done was to adjust the reflow profile so as to be hotter and longer in the reflow state. Am I wrong here? I thought th
Electronics Forum | Fri Jul 06 18:17:34 EDT 2001 | davef
We find no solder balls after washing our boards. It works GREAT!!! ;-) Probably more to the point, look at "Circuits Assembly" 7/01, p 40, "Eliminating Solder Beads In No-Clean PCBs". "Solder mask type & composition are the greatest contributor t
Electronics Forum | Thu Jul 05 07:34:57 EDT 2001 | steven
what is the main reasons that casuing solder ball during reflow? and how to remove them? (mostly arround the connector leads or between the 2 0402 chips). solder paste is RMA type. need advise. thanks