Electronics Forum | Tue Oct 21 12:10:04 EDT 2008 | jdumont
Do your boards only have three parts on them? Otherwise, i dont see how this is possible. Do you scrap the board if there is an issue or do you fix it and make it look like reflow soldering?
Electronics Forum | Sun Apr 25 10:28:46 EDT 1999 | Joe Cameron
Hello all, Been doing some comparisons on joints made using the soldering iron versus reflowed solder paste (on a QFP package). The difference is quite significant: the joints made by the soldering iron are inconsistent and in many cases not filled
Electronics Forum | Thu Dec 09 07:46:42 EST 2004 | davef
We did this for BGA pads, but have not thought about other types. So, this may or may not apply for those. Pad defined by:||Advantages||Disadvantages Non-solder mask||No point-of-stress concentration at edge mask and solder ball||Smaller pads have
Electronics Forum | Fri May 21 12:25:14 EDT 1999 | Dave F
| Has anyone had any experience or data using vibration during the reflow process. | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process worked v
Electronics Forum | Tue Nov 13 21:59:42 EST 2007 | davef
This processes has the potential to cause barrel cracking and pad lifting, because the heating is very hot [troop crank-up the volume on their iron when they see thick boards] for a relatively small area on one side of the board. What do we suggest
Electronics Forum | Tue Sep 20 17:09:14 EDT 2005 | hly
I have a situation with hot boards with fine pitch BGAs that I need to build. However, there is a big problem--the auto screen printer is down. I decided that we would use the stencil and manually line up the pads and do a manual print. I can't ac
Electronics Forum | Wed Oct 30 16:05:08 EST 2002 | msimkin
Hi, I have received a report form a board supplier, analysing the reuslts form non wetting problems we have been expereincing with their boards. I assumed it was due to the gold layer being too thin, thus allowing the nicklel layer to be exposed and
Electronics Forum | Fri Apr 16 11:07:53 EDT 1999 | Vic Lau
| | We process both tin/lead plated boards and gold plated boards in our surface mount group. I have used Sn62/Pb36/Ag2 solder paste on all gold plated boards to help prevent gold scavaging. To reduce the amount of different solder pastes we have t
Electronics Forum | Fri May 21 15:23:24 EDT 1999 | JohnW
| | Has anyone had any experience or data using vibration during the reflow process. | | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process work
Electronics Forum | Thu Jun 27 11:22:03 EDT 2002 | robbied
Hi there. We have had an out of control reflow oven that has allowed its temperature to fluctuate by up to +/- 20 deg C from set point in very short periods of time. We found the root cause of the problem and fixed it, but by then we had already run