Electronics Forum | Wed Jan 05 16:46:44 EST 2000 | Dennis O'Donnell
Several methods work well. 1. (Low Volume Method) Using an Xacto blade, scrape off the solder mask holding the blade flush being careful not to use the pointed part of the blade. 2. (High Volume Method)Tape off the area that you don't want the mas
Electronics Forum | Mon Aug 09 04:15:33 EDT 1999 | Jacqueline Coia
I am having cleaning problems when processing PCB's which have TAIYO solder mask on them. After processing, hand soldering and cleaning, a sticky residue is remains, resulting in a cosmetically poor finish with tide marks etc. Other soldermasks do no
Electronics Forum | Mon Nov 08 12:47:52 EST 2004 | clampron
Good Day Everyone, I have a BGA rework that has some chipped/damaged solder mask that will need to be repaired prior to BGA replacement. I was wondering what materials are being used in the industry for this type of application. Any help would be g
Electronics Forum | Mon Nov 08 17:47:58 EST 2004 | davef
Russ: On "usually get some mask material from our board house. It cures with heat so it works really well in our applications.": We're unsure about the type of mask that you are using, but be careful [we used to do this, also]: * Final cure of the L
Electronics Forum | Wed Jan 13 11:21:22 EST 1999 | Patrick O' Herlihy
Can anyone recommend ways of reducing damage to solder masks ... a new wick perhaps. I find that using standard wicks the imposed damage is un-acceptable. Also any good links on the subject of bga rework would be really appreciated in earnest ...
Electronics Forum | Mon Jan 18 20:51:29 EST 1999 | Dave F
| Can anyone recommend ways of reducing damage to solder masks ... a new wick perhaps. I find that using standard wicks the imposed damage is un-acceptable. | | Also any good links on the subject of bga rework would be really appreciated | | in ear
Electronics Forum | Thu Dec 09 07:46:42 EST 2004 | davef
We did this for BGA pads, but have not thought about other types. So, this may or may not apply for those. Pad defined by:||Advantages||Disadvantages Non-solder mask||No point-of-stress concentration at edge mask and solder ball||Smaller pads have
Electronics Forum | Wed Jan 05 14:45:14 EST 2000 | Hoyt Moore
Does anybody know how to remove solder mask from pads that were masked over.
Electronics Forum | Fri May 21 09:48:30 EDT 2010 | tomg_fla
Am looking for a dispensable water soluble solder mask or peelable solder mask that can be dispensed and be run through a reflow oven with no swelling or degradation. Any leads on any materials or manufacturers to contact?
Electronics Forum | Wed Dec 18 08:38:17 EST 2002 | davef
Thanks Tim. Additional thoughts are: * We've talked here on SMTnet about hole fill previously. * That your ability to get hole fill is probably limited by mask in the hole makes us very uneasy, because hole could have varying levels of solder mask i
winsouce.jpg)
