Electronics Forum | Fri May 28 17:30:35 EDT 1999 | Dave Clements
I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is about
Electronics Forum | Fri May 28 17:44:51 EDT 1999 | Glenn Robertson
| I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is abo
Electronics Forum | Wed Feb 28 03:57:46 EST 2001 | peterbarton
Are you using a water based flux? Are the solder balls mainly around or near non-plated holes or near the edges of the PCB? If so the preheat must be set so the water content of the flux is fully evaporated before the board hits the solder wave. If
Electronics Forum | Thu Aug 06 09:51:20 EDT 1998 | Bob Willis
This text may be of interest to any one with tin lead spots Guide to Solder Spots - A New Plague in Manufacture ? So what are solder spots ? They appear to be the next big problem in modern reflow assembly in fact in any process that involves solder
Electronics Forum | Sun Aug 03 08:27:41 EDT 2008 | davef
IPC-4553, Specification for Immersion Silver Plating for Printed Circuit Boards, 1.4.1 Solderability. This primary function of IAg is to provide a solderable surface finish, suitable for all surface mount and through-hole assembly applications and wi
Electronics Forum | Mon Jun 08 13:26:59 EDT 1998 | D.Hammond
I work QA at an OEM in Alberta, Canada. I saw earlier posts on the smtnet regarding PCB haloing criteria. I am currently in a dispute with my PCB vendor over the acceptability of haloing (delamination) around plated through holes and vias on a lot of
Electronics Forum | Wed Apr 06 11:10:47 EDT 2005 | smt_rookie
We process a double-side reflow board (10 ups). Chips and IC's on the bottom side while chips, IC's plus thru-hole connectors and IC sockets on top side (bottom side first then top side reflow). In the past, we were not encountering any soldering pro
Electronics Forum | Mon Dec 13 00:48:33 EST 1999 | armin
Hi All I have a 0.7 mm diameter hole for vias, what�s the minimum annular ring for this hole diameter? What�s the term unsupported and supported holes refer to in IPC-2221 9.1.2 Annular Ring Requirements? I have a proto-type PCB (designed by our R&
Electronics Forum | Mon Jun 08 15:01:02 EDT 1998 | D.Lange
| I work QA at an OEM in Alberta, Canada. I saw earlier posts on the smtnet regarding PCB haloing criteria. I am currently in a dispute with my PCB vendor over the acceptability of haloing (delamination) around plated through holes and vias on a lot
Electronics Forum | Tue Dec 21 17:11:18 EST 1999 | Pascal G
Hello guys , we just started first trials on PTH connectors mounted in SMD. Our first results show big deviation of solder filing in the hole and also a dramatic decreasing of mounting spped on pick & place equipement. 1 - Did someone uses proflow
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411