Electronics Forum | Wed Apr 23 11:41:53 EDT 2003 | k_h
I've never heard of steaming a board either. You said that steaming cleans it better after the wash process. What is the steaming process cleaning that the washer isn't, flux residue, solder balls, or what? Also, try and identify the main difference
Electronics Forum | Wed Sep 03 18:20:00 EDT 2003 | davef
Major advance: Productionization of SMT. Minor advances: * Realization and control of solder paste characteristics * Vision alignment controls in printers. * Evolution from mechanical centering [through laser alignment controls] to vision alignment
Electronics Forum | Tue Jan 13 04:35:26 EST 2004 | pablowe
We have done some trials with Lead free which appear to have gone well. We will be introducing a number of new products over the coming months and it is an opportune time to begin using lead free on these products which will be required by law in the
Electronics Forum | Thu Mar 25 08:25:20 EST 2004 | Just another guy with Trouble
I need a source to get several thousand SMT ICs re-tined, does anyone know of anyone that can do this for us. the parts are in tape and reel and will need to be repackaged also. We are in a bind the part itself is an end of life component and these w
Electronics Forum | Thu Apr 15 16:07:37 EDT 2004 | barry
Hi there all, we are having problems with 2 qfp devices. grainy poorly reflowed solder joints. One 100 pin .5mm pitch, and one 64 pin .5 mm pitch . Both of these devices have a thermo pad on the back of them (pad area soldered to back of device)which
Electronics Forum | Thu Jun 17 07:04:03 EDT 2004 | davef
It sounds like the parts are not soldering properly [have poor solderability]. This probably due to corroded nickel underplate caused by: * Nickel that oxidized, while awaiting overplating * Poor quality tin overplate, allowing nickel to oxidize aft
Electronics Forum | Wed Jul 07 13:37:56 EDT 2004 | mark
Not sure if this helps but found this site that outlines % of N2 against O2 ppm levels. You need 99.99% N2 purity for http://www.tkb-4u.com/articles/consumables/whatisnitrogen/whatisnitrogen.php Most customers we have worked with in the past run an
Electronics Forum | Thu Jul 15 22:03:07 EDT 2004 | KEN
In no particular order: Will the failed joints wet when touched with an iron + flux? Is there flux surrounding the joint (post reflow). If no, you may be baking it out premateurely. Is this assembly wave soldered? Where is defect discovered in yo
Electronics Forum | Mon Jul 26 09:19:57 EDT 2004 | davef
Both imm silver and ENIG provide flat surfaces that are better for fine pitch placement and reflow than HASL. We know of nothing that makes BGA locations different than other locations when using ENIG solderability protection. More broadly, the pri
Electronics Forum | Wed Aug 18 10:34:35 EDT 2004 | russ
We do this every day, We print the bottom side, then the top, and have a tool that presses the connector on. We then process the board down the line. The only tricky thing is keeping fingers out of paste. Fortunately this is a single sided board.
Capital Equipment Solutions - SMT | PCBA | TEST
Equipment Dealer / Broker / Auctions
113 S Main Street
Lodi, WI USA
Phone: 6083431779