Electronics Forum | Wed Mar 07 20:37:38 EST 2001 | davef
I agree. The bar coded label you use should not be affected by the solder mask of the board. The label should have sharp contrast between the segments of the code to modulate the returned light and allow the reader to discriminate between light and
Electronics Forum | Wed May 25 19:25:24 EDT 2022 | jojoled
Thanks "Spoiltforchoice" for Informations, I have found allready a Chinese company which has such machines, just wanted to check other options from other countries too. I know it is from other end of linear process, but from my point of view (plus wh
Electronics Forum | Tue Nov 08 16:21:37 EST 2011 | nevercry14
Cannot zero set machine actuator problem need help.
Electronics Forum | Wed Nov 09 08:29:51 EST 2011 | nevercry14
Found y sterper motor not working .nthanks for the info.
Electronics Forum | Tue Nov 08 18:27:50 EST 2011 | dekhead
Not a lot of info; first thought is 12VDC - PSU, breaker, fuse http://www.dekhead.com
Electronics Forum | Thu May 26 07:53:42 EDT 2022 | jojoled
Hi.Thanks for reply. 1. - I guess after JETting the paste, the head will go aside, to allow head with HD camera(SPI) to do the job.....and thus if used for AOI , the same camera will be much higher above components, not damaging anything....this is
Electronics Forum | Wed May 25 23:45:04 EDT 2022 | SMTA-64387687
1. The jetting head flies very low to the level of the board. So, performing AOI function will crash the head. 2. AOI is performed close to the end of the line, after P&P or reflow. Are you planning to run the boards back-and-forth, on the line? 3. L
Electronics Forum | Fri Jan 28 19:26:51 EST 2011 | jlawson
Milara has a combined Stencil printer + jet Printing ??? Print and then jet print areas not printed or top up prints.
Electronics Forum | Mon May 12 11:59:12 EDT 2008 | vms
todd the best answer is this" don't use the dispenser it will waste to much solder paste" Harry
Electronics Forum | Fri May 09 14:56:37 EDT 2008 | markhoch
The paste dispensers work well as long as the humidity in your shop is properly controlled. If it gets too humid, and the paste gets "soupy", then it will take less air pressure to dispense it onto the stencil. Paste dispensers use a controlled, pre-
