Electronics Forum | Fri Dec 07 02:10:26 EST 2007 | mpolak
Hi, Could you guys verify my BTU VIP98N oven settings for lead free process. At the moment as my standard profile im using these settings 140 160 180 207 205 220 257 same temps for bottom and speed 50cm/min. Has anyone got same oven and could
Electronics Forum | Sat Nov 13 12:22:55 EST 2004 | GS
Hello, very interesting informations you can find on: - IPC-CH-65A Guidelines for Cleaning of Printed Board and Assemblies. - IPC-AC-62A Aqueous Post Solder Cleaning hand Book GS
Electronics Forum | Tue Nov 08 16:21:37 EST 2011 | nevercry14
Cannot zero set machine actuator problem need help.
Electronics Forum | Wed Jun 14 21:49:42 EDT 2006 | davef
Bryan: * Most of our stencils are made from stainless steel that is held by a aluminum frame, attached with epoxy with a fiber glass intermediary between the frame and the stencil. * We use stencils to print either glue [thermoset epoxy] or solder pa
Electronics Forum | Sat Oct 25 13:36:39 EDT 2014 | sonavc
Hi everyone, hope you can help me with this machine I bought used and after it is set up , it runs good, home position. I can click the tab Start, and Setup. But I can't click the tab I/O , edit or system. Because, I think I can't log in the Level
Electronics Forum | Thu Sep 26 14:03:55 EDT 2002 | Randy V
There are allot of issue to washing that need to be considered before you purchase a washer. But to answer your question regarding ultrasonic cleaning: 1. Ultrasonics with the correct frequency will not damage most components. Washing in general can
Electronics Forum | Thu Feb 10 13:54:22 EST 2000 | Kris W
Hi All, We are in the process of converting from RMA solder paste to no-clean process across the shop. This will allow me to carry my semi-aqueous cleaner out of the building and set it ablaze using the terpenes as the fire water. Then I can go ab
Electronics Forum | Tue Sep 07 15:28:13 EDT 1999 | Earl Moon
Listed below are the issues Viking has been experiencing since the installation of the Proflow Head: 1. After installing new 350mm Wiper foil with metal strip glued on it, It worked for about a week and suddenly metal stri
Electronics Forum | Wed Sep 08 08:25:26 EDT 1999 | Brad Kendall
Listed below are the issues Viking has been experiencing since the | installation of the Proflow Head: | 1. After installing new 350mm Wiper foil with metal | strip glued on it, It worked for about a week and suddenly meta
Electronics Forum | Fri May 09 14:56:37 EDT 2008 | markhoch
The paste dispensers work well as long as the humidity in your shop is properly controlled. If it gets too humid, and the paste gets "soupy", then it will take less air pressure to dispense it onto the stencil. Paste dispensers use a controlled, pre-