Electronics Forum | Tue Dec 10 14:10:38 EST 2002 | Randy Villeneuve
Steve, I wave solder most if not all our boards with selective wave pallets. I did not catch if the solder balls were on top of the board or on the bottom but that will make a difference on what to do to get rid of them. Pallets are good and bad. On
Electronics Forum | Thu Sep 21 17:50:43 EDT 2000 | Bill Boles
Does anyone have a quick reminder for a PCB with immersion gold surface finnish going through a reflow profile: Which of the following statements is more correct? A: In order to minimize gold in the intermetallics of the solder joint, the board temp
Electronics Forum | Sat Mar 20 06:18:58 EST 2004 | agp
I haven't heard of anybody yet who have done smt and reflow after thruhole and solder wave. Thru hole components usually have low resistence to heat and could easily burn when subjected to the 210deg-245deg.C reflow temperature. For pc boards with co
Electronics Forum | Fri Jan 15 13:35:03 EST 1999 | Terry Burnette
| I saw the problem of void in solder bump or in lead less component or some BGA. But I didn't have standard specification of that void is accept or reject? Do any body have the better idea or suggestion of the criteria ? | | Thank you, | Wirat
Electronics Forum | Fri Aug 06 10:27:05 EDT 1999 | Kenneth Hedman
| | I saw the problem of void in solder bump or in lead less component or some BGA. But I didn't have standard specification of that void is accept or reject? Do any body have the better idea or suggestion of the criteria ? | | | | Thank you, |
Electronics Forum | Thu May 28 09:23:59 EDT 1998 | Chrys
| Hello, | | I need some users information about "hot air knife" after the wave | bath: | - Defects reduction ? | - In what kind of boards(TH/SMT SOICS ect.) it is applied ? | - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ? |
Electronics Forum | Wed Jan 30 08:30:33 EST 2002 | seto
Hello Dave, Mechanically the conection between the component pad and PCB pad is good (the solder joint is very strong). The problem is associated with poor contact after the use by the customer (vibration, temperature, etc). You can see the pictures
Electronics Forum | Tue May 26 06:56:40 EDT 2009 | xinxi
Hi! From your post, it seem like the wave did not really touch the component. You probably need to get the both wave height correct and that it hits the component.It is normal for solder to come through the PCB when using chip wave. The through-hole
Electronics Forum | Wed Jun 27 21:53:54 EDT 2012 | davef
Questions are: * When you rework these pads, can you get solder to flow on the pads with a soldering iron? * When you profile the board during reflow, what is the temperature on these pads as compared with other similar pads in the vicinity?
Electronics Forum | Thu Feb 19 12:56:29 EST 1998 | Earl Moon
| I'd like someone gives me a tip for elemating of voids | in the mico BGA solder joint and the method of inspection | of them, very exactly. Voids in excess of 20% by each solder ball volume is cause for rejection. Causes are improperly managed proc