Electronics Forum | Fri Jan 24 17:05:37 EST 2003 | pjc
Correction: The Ultrapak (UPK) 600 and Electra models allow for conveyor incline adjustablity from 4 to 7 deg.
Electronics Forum | Fri Jan 24 17:00:56 EST 2003 | razan3
RMA needs to be dry prior to the wave to work. If coverage is good and part orientation is good, then you should be okay. Pad size can be adding to the amount of material left as well. Granted it soldered before fine with .2 long leads, I would di
Electronics Forum | Fri Jan 24 09:26:29 EST 2003 | pjc
I sent you a couple of charts to assist with your troubleshooting. One is the Electrovert Wave Solder Troubleshooting chart and the other is Sandia Labs/Electrovert Optimum Solder Contact Time. Electrovert has a 6 deg. conveyor angle standard on the
Electronics Forum | Fri Jan 24 09:04:54 EST 2003 | russ
How are these connectors and dips oriented? If the leads are parallel as opposed to perpendicular to to the wave this can promote bridging depending on spacing and length. The long leads showing icicling are most likely either inadequate heat OR the
Electronics Forum | Thu Jan 23 20:27:54 EST 2003 | joeherz
Hello, We recently installed a new/used UPK 650 fitted with a foam fluxer using an RMA flux chemistry. We have had problems with icicling and bridging from the beginning. The bridging occurs mostly on DIPs and connectors. The icicling is on longer
1 |