Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant
hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2
Electronics Forum | Tue Feb 14 03:58:17 EST 2006 | Rob
Yes, it's fine - as Pete says you have to replace certain parts & either get the pot recoated or a new one. We ran a "Lead free" 6622C from Vitronics Soltec on Tin Lead, then it was cleaned up, recoated and loaded with a no-lead alloy with no proble
Electronics Forum | Sat Aug 23 12:47:54 EDT 2008 | bruna
Hi! Does any one can give the reason of the black dust into de wave solder machine. We can found no reason for that, but the machine get dirty to fast despite the maintenance. Thanks for your time Bruna Neto
Electronics Forum | Tue Aug 08 12:49:33 EDT 2023 | serge_pirog
I ask for advice on starting wave soldering machine. The soldering machine is not new. Are there guidelines for properly loading solder into a bath and more. I also ask you to recommend an alloy. What do you think about Alpha Sn Plus 07 or SN100C(Sn
Electronics Forum | Mon Aug 25 08:33:59 EDT 2008 | lococost
That's just dross. If you have nitrogen blowing over the wave, you could reduce its flow as it tends to blow the dust everywhere if it is set too high. (on the other hand it might reduce solder quality)
Electronics Forum | Wed Aug 27 16:31:45 EDT 2008 | bruna
hi loco, Thanks for your post, it was very helpfull.
Electronics Forum | Thu Aug 10 08:26:42 EDT 2023 | serge_pirog
Heeb inotec HWL 330
Electronics Forum | Tue Aug 08 20:39:29 EDT 2023 | cbeneat
What manufacturer is it? I usually stack the bars in as tight as possible. Especially against the wall of the pot with heaters. While it's heating keep applying slight pressure with a bar of appropriate material, towards the sides to facilitate melti
Electronics Forum | Thu Jul 27 12:12:02 EDT 2000 | JohnW
Wilson, I'm sure both Electrovert (electra?) and Soltec have machines in their rangs that will open to this size... Out of interest...what type of board is it?
Electronics Forum | Fri Jan 28 12:30:57 EST 2005 | glenda
We are looking for a used or new wave machine must be able to do lead free solder. Does anyone have contact information in the Chicago, il area for used wave soldering machines? Thanks for any help we can get.
.gif)
