Electronics Forum | Tue Apr 03 06:08:11 EDT 2012 | rpa
Hi, where can i place a manual tray feeder on OPAL XII - Assembleon. I tried to put the tray on rear side feeders positions and teached components array positions but an error occurred "software outlimits".
Electronics Forum | Tue Nov 17 10:55:17 EST 2009 | tpappano
I have a CSM84VZ, so I was thinking of a device that could be placed on it's "manual tray feeder" instead of one of the 9" wide plastic matrix trays that TQFPs, etc. are supplied in. The machine would be programmed to pick parts from several single-
Electronics Forum | Thu Mar 30 00:47:57 EDT 2017 | mrpackethead
I am trying to set up a YV100ii machine to pick up TQFP's from a manual tray. No matter what i do, it doe snot want to pick up the parts from the tray, but it keeps wanting to try to pick up parts from the place that a feeder would present the part.
Electronics Forum | Wed Jan 19 11:44:47 EST 2011 | davemac62
I have a Topaz with 2 positions in the rear where component trays may be placed for limited tray component capability. There is not a lot in the manual on how to set this up. The Feeder Plate info is set up to allow Fix.tf. I have spec'd tray - fix.t
Electronics Forum | Sat Dec 03 01:07:29 EST 2022 | poly
I've got access to the universal manuals / voyager but I haven't found a section that describes the feeder teach setup process, I can pick up the teach slug onto the conveyor and then get into feeder teach but if I teach the corners of the slug as t
Electronics Forum | Tue Aug 20 14:18:06 EDT 2002 | larryk
Kevin, I saw a few months ago in a Philips pamphet that they now have a "tray" that sits at the feeder locations for loose components or a small tape of components. I think it was for the Topaz machine.
Electronics Forum | Wed Aug 21 18:13:21 EDT 2002 | johnlee
Kevin, There are a number of custom integrated systems that perform automated insertion of "odd" components. These system use either a robot or cantilevered X,Y,Z Cartesian motion systems. Our systems have accepted standard and custom component feede
Electronics Forum | Thu May 10 13:53:36 EDT 2001 | stefwitt
If you get the price for the tray and holder from Siemens you will follow Dave's recommendation. To get the 0 point for the tray ( from where you measure the first pick position )you set up the tray on the 7th track ( type 51 ). After you sent the da
Electronics Forum | Thu Apr 04 07:09:39 EDT 2013 | leemeyer
Autoprogram will use whatever tape feeder width is defined for that component (SMD type)and will adjust the pickup accordingly. Autoprogram will not tell you where to place Vibs and Matrix trays. You need to decide where to mount the holders. Then m
Electronics Forum | Fri Jul 31 17:03:21 EDT 2009 | isd_jwendell
My Essemtec machine can use "restband" feeders. They are manual feeders that simulate trays, but are specifically made to hold tapes.
.gif)
