Electronics Forum | Mon Sep 20 15:32:27 EDT 2010 | naveed
Yes!tahnkx I made a backup disc.the all data for production files,and also the data base library(vision files for component and fiducials) has been copied to the disc.we are in contact with yamaha consultant,they sent us the new manual which has the
Electronics Forum | Mon Jan 18 12:20:28 EST 2021 | tamcrocker
Thank you for the respond, will check out the switch and give the Alpha 1 Technologies a call if the switch is not the problem.
Electronics Forum | Mon Jun 21 13:16:18 EDT 2021 | tomdegas
I just received the following messages while running our MY15: I-OSM-0: my15n150 kernel: lp: no devices found. I also received this one: I-OSM-0: my15n150 insmod: /lib/modules/2.2.20/misc/lp.o: init_module: Device or resource busy. And this one: I-
Electronics Forum | Tue Nov 20 13:15:56 EST 2012 | bk
Well before you totally give up on the midas head, you may wanna try changing out the ffx board/cable on it to make sure the one in there isn't binding once in a while and giving you your theta errors.
Electronics Forum | Thu Jan 12 20:54:30 EST 2023 | cbeneat
When I see that on ours, I take the nozzle off and clean the tip. Any build up and the machine throws that error. Do a set check on the head and then look at the image of the nozzle in question...OR we hit resume and the machine ignores it until the
Electronics Forum | Fri Jun 24 15:03:20 EDT 2005 | Shannon D
Contact Mike Tieman at Quad Care 859-442-0776. I have used him in the past. He's sharp and honest.
Electronics Forum | Thu Feb 02 13:20:28 EST 2006 | bobpan
shoot me a question and i will be glad to help....but you really should start a new thread....than to keep this old one going.
Electronics Forum | Mon Feb 06 20:57:51 EST 2006 | bobpan
Mazin, Give me some more information as to what originally caused the problem, Was there an electrical storm, was someone programming when the problem happened, Did you start it up and it happened, etc...etc... The more information the BETTER i can h
Electronics Forum | Thu Aug 06 20:08:35 EDT 2015 | edwaterfall01
It could be a blown fuse on the power distribution panel or a failed power supply. Check the power distribution board in the front lower center of the machine. There are 11 LEDs on the board and 10 should be ON
Electronics Forum | Tue Oct 06 20:18:27 EDT 2015 | edwaterfall01
With the address of FC107F24 I would look at the Slot 11 UIMC board. Try swapping with another Radisys Board. Check jumpers, changing one jumper only on each board.
