Electronics Forum | Wed Jul 05 17:37:46 EDT 2017 | tobytoby292
I have a UP-100 screen printer that was locking up on me by removing my cursor and not allowing any button presses. I did a hard reset and this fixed it temporarily i now have encountered a new problem where the unit displays a "communication error""
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Fri Sep 17 23:59:40 EDT 1999 | JAX
| | | HI everyone, | | | | | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00
Electronics Forum | Fri Sep 17 21:25:00 EDT 1999 | Rob
| | HI everyone, | | | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 an
Electronics Forum | Thu Sep 23 21:51:27 EDT 1999 | harry
| | HI everyone, | | | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 an
Electronics Forum | Mon Sep 20 11:53:41 EDT 1999 | Scott S. Snider
| HI everyone, | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 and .001
Electronics Forum | Fri Sep 17 15:43:08 EDT 1999 | Dave F
| HI everyone, | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 and .001
Electronics Forum | Tue Mar 02 17:26:24 EST 2004 | pjc
I worked on MicroFlex. All axis move via electric motor drive. Carraige reapatability is +/- 0.0005" (12 micron). Cameras position more easily on linear bearings than the swivel type. The alignment accuracy and repeatability easily supports sub-20mil
Electronics Forum | Tue Apr 21 02:28:54 EDT 2015 | dinhhuunam
Juki GL-1.... Any thoughts? I'm New to the > industry and I'm trying to buy a new screen > printer. I have two in mind, DEK and Juki. Hi Sir, I'll advise you the SJ INNOTECH Vision Screen printer Best Solution & Service for You Model HP-520S Hi
Electronics Forum | Mon May 03 20:17:40 EDT 2004 | Jacek
Try to check axis drivers - at the begining should be tactile. When you press RESET look on the screen - is there any change (position send from encoders) ?
winsouce.jpg)
