Electronics Forum | Mon Oct 07 02:55:56 EDT 2019 | kwozniak
Hello everybody, if someone have KY-3020T calibration and maintenance manual instruction in pdf, please send me to my mail wozniak.j@assel.pl Regards
Electronics Forum | Thu Dec 09 21:46:22 EST 2021 | dwl
Totally agree with Evtimov. Let the SPI be the judge, as long as your getting good prints, your stencil is fine. I had a colleague cut the mesh on one side of a stencil and it still printed fine. This was proof to management that measuring tension w
Electronics Forum | Sun Jun 16 05:23:28 EDT 2024 | ushir
Hi guys Our Koh Young SPI 8030-2 seems to be slightly out of calibration where the camera is out of focus slightly. Does anyone know what the calibration procedure is? Thanks
Electronics Forum | Mon Jun 17 11:37:57 EDT 2024 | linux
Do you have the calibration Jigs
Electronics Forum | Wed Jun 19 19:52:49 EDT 2024 | ushir
No. I should have probably mentioned that I need those as well!
Electronics Forum | Thu Jun 20 08:59:19 EDT 2024 | linux
No point looking for procedure if you don't have the Jig. I'm not aware of any company that going to give you a calibration jig set.
Electronics Forum | Thu Jun 20 11:26:03 EDT 2024 | carl_p
Have you tried the easy approach of reteaching the board zero?? If you don't have the full cal jigs your only options will be to buy or get a rep/eng in to do it for you. If your buying the Cal jigs used, you would have no idea if they are good unl
Electronics Forum | Fri Jan 31 08:45:30 EST 2020 | ilavu
I have one Pemtron SPI TROI-5500H machine and hard drive crash on it. I am trying to get it back up and running. I install the XP and old version of TROI software. Currently i am trying to calibrate the machine and no luck. During the PZT calibration
Electronics Forum | Thu Jan 05 09:05:21 EST 2023 | tommy_magyar
Hi, I think this can only be done by a lab analysis by the machine supplier + a calibration tool they give you and you do a repeated number of measurements periodically. Or you can just call the service engineers out and they do it themselves. You sh
Electronics Forum | Tue Jun 06 13:47:10 EDT 2023 | oxygensmd
In Hungary there are many EKRAs. Bosch, Zollner and many big/small company are using them. I also saw the latest DEK but I think DEK is over-complicated, fast and good printer - but if you have any problem, it cost a lot. MPM also nice machine but I
.gif)
