Electronics Forum | Wed Jun 13 17:15:48 EDT 2001 | medernach
Yes, I've seen it recently and it's most likely a component problem. A cap is essentially a sandwich comprised of multiple layers. the layers are either wet film or dry film. The end terminals may either be hot soldered or sputtered so there are a
Electronics Forum | Thu Aug 30 06:57:56 EDT 2007 | simonalden
Hi we are currently experiencing a problem with solder contamination of the gold contact pads on our pcbs following the reflow process, possibly through sputtering. We have been advise that this can be caused due to the pcbs being humid or due to th
Electronics Forum | Mon Mar 29 04:00:01 EST 1999 | Vinesh Gandhi
Glenn, i am aware of one unique problem with voc free fluxes. since these fluxes have certain amountb of water content they cause sputtering leading to solder balls & voids problems. Regards Vinesh Gandhi | I require some feed back from any one
Electronics Forum | Wed Nov 30 15:15:34 EST 2016 | warwolf
Any lead free will eat a leaded designed wave soldering machine. But SN100c will eat it the slowest, our soldering tips used to only last 3 months with SAC305 when we changed to SN100c solder wire we are having around 9 months tip life. Our wave sol
Electronics Forum | Tue Jun 22 17:14:41 EDT 1999 | Dennis Fall
I am looking to apply 10-15�m of a conductive material that will withstand 280�C. Our product consists of an alumina substrate sputtered with NiCr (2000�) and Copper (2000�) and 15-60 �m of electroplated copper (all metals patterned on the substrae)
Electronics Forum | Wed Jun 23 10:21:25 EDT 1999 | Chrys Shea
| I am looking to apply 10-15�m of a conductive material that will withstand 280�C. Our product consists of an alumina substrate sputtered with NiCr (2000�) and Copper (2000�) and 15-60 �m of electroplated copper (all metals patterned on the substra
Electronics Forum | Wed Aug 04 11:01:46 EDT 2010 | ooskii
I have a question concerning what plating will go into solution during the reflow process. I am soldering a small piece of ceramic (120x180 mils 7 mil thick) onto a flex circuit. I am seeing some fractures that I am sure are being caused by handlin
1 |