Electronics Forum | Mon Feb 27 13:02:34 EST 2012 | cyber_wolf
The clutches are dirty and slipping. Sincerely, Estimated
Electronics Forum | Tue Feb 21 18:32:12 EST 2012 | skatemo
Hello estimated Someone can help me with a problem that I have in one cp643 which marks the stations 17 and 19 of almost all the holders, already there changed the amplifiers of both stations and were calibrated but it follows the problem. Thanks.
Electronics Forum | Tue Feb 28 21:18:49 EST 2012 | skatemo
Hello friend, also cleans the clutches, several times but he continues presenting the same problem. I suspect in a few holders that we buy, for that from that they established themselves I present this fault
Electronics Forum | Wed Feb 29 10:00:48 EST 2012 | cyber_wolf
In order to clean the clutches properly, you must disassemble them. Did you do that ? The nozzle holder sensor dogs must be clean and scratch free.
Electronics Forum | Thu Mar 22 17:18:17 EDT 2018 | rodrigo
Hi all, Our (new/used) CP642 resets the nozzles heads first time I do a nozzle centering after power on. But we're getting errors st17 and st19 and while working on the sensors I noticed that it does not resets the heads before I start a nozzle cent
Electronics Forum | Sat Jan 21 19:44:07 EST 2006 | vincent
i have a problem similar to Daxman where cp6 usually having problem when it run at high speed, the head seems to have problem returning back to its origin at st12 and stop at st15 and st19 for nozzle change error, when rotating the head by hand, some
1 |