Electronics Forum | Wed Nov 17 11:18:14 EST 1999 | Larry
I have a Alphametals Omega meter, model 500. I am looking for a place to purchase the standardizing solution #3. I have already asked Alphametals but did not recieve any response from them. does anyone know fo another source for this solution? Larry
Electronics Forum | Fri Jul 29 12:26:41 EDT 2005 | DannyJ
Good day everyone, I'm hoping that there are a few of the Westek Ionic Contamination Tester systems out there... I am in need of standardization solution for this unit and my current suppliers have dried up. I was purchasing from Stoelting, #1-67
Electronics Forum | Tue Aug 09 09:13:45 EDT 2005 | davef
You should use deionized water and laboratory NaCl. Try a local college or high school for the NaCl. Otherwise, order it from a laboratory supply house [eg, Fisher Scientific, Spectrum Chemicals, etc].
Electronics Forum | Thu Dec 06 07:54:06 EST 2012 | cnotebaert
You will also need a standardize solution to calibrate your 75/25 ips/DI mixture. Trek/westek is no longer, I think stoelting now supports the system though.
Electronics Forum | Tue Aug 09 10:53:10 EDT 2005 | DannyJ
Hi Dave, Thanks for the suggestions. Those did cross our mind as an option, and kind of saving that for a last resort. We just hope we have enough left for them to do an analysis and come up with the right solution. We may have found a supplier
Electronics Forum | Thu Oct 16 11:15:53 EDT 2008 | davef
A good solder connection with heavy ground plane requires: * Plenty of heat [Is the preheater located too far from the wave? Whenever you look at board temperature, there is a sharp decrease in temperature between the preheater and the wave.] * Conta
Electronics Forum | Thu Jul 06 03:43:22 EDT 2017 | jamesbarnhart
Electronic devices required higher speed, I/O capability, and density to meet standard requirements. Automated robotic soldering solutions that meet the demands of applications are too challenging for hand soldering. Manual soldering, even with the m
Electronics Forum | Thu Sep 22 11:06:12 EDT 2005 | smtsales
I have a software solution for using a standard pc to interface with your MCS30 if interested email me at smtsales@hotmail.com
Electronics Forum | Wed Dec 05 23:31:12 EST 2012 | aqueous
This is a (Resistivity of Solvent Extract (ROSE) tester. Per IPC standards, ROSE testers use a test solution comprised of 75% IPA (99% pure) and 25% DI water. -Mike Konrad Aqueous Technologies www.aqueoustech.com konrad@aqueoustech.com
Electronics Forum | Sun Aug 25 02:15:48 EDT 2013 | alexeis
Hi, Our software solution (called QPlan) is using IPC standards and many more in simulation of SMT production.
.gif)
