Electronics Forum | Fri May 06 16:19:40 EDT 2005 | jdengler
Does the problem happen at start-up? Does the servo amp have an error? If yes to both, could be a bad cable, or a badly tuned servo amp. If after running and the amp has an error it could still be the cable but also brings in things like a bad motor
Electronics Forum | Tue Jun 20 19:12:41 EDT 2023 | madisreivik
Hello all ! FUJI IP3 starts up, makes zero setting OK But if I start AUTO mode, it gives error -------------------------------------------------------------------------------- Code 11082010 UsedBy MTU3,MTU4,MTU5 Display Usable Proper Data has
Electronics Forum | Sat Jan 20 23:48:55 EST 2007 | bvdb
Hi Al, Thanks for the suggestion. Yes, I should have said that the cable has been checked and another cable tested with the same results. In addition to the three wires that carry the transmit data, the receive data and the data signal ground, the
Electronics Forum | Sat Jan 20 17:41:11 EST 2007 | bvdb
Hoping someone can help us. Our Fuji IP-1 won't boot up unless we disconnect the 25 pin RS232 connector that runs to the MCS16/F programming computer. It doesn't matter if the 9 pin connector on the other end of the cable is plugged into the MCS16/
Electronics Forum | Thu Jun 29 23:54:06 EDT 2006 | grantp
Hi, I think it's a good choice for a startup, and if your finding it's accurate enough. We only went Fuji because of our volume, and small errors were adding up, but if I was starting from nothing again it would be MYDATA because I could not afford
| 1 |
