Electronics Forum | Mon Oct 13 13:49:29 EDT 2003 | mrmaint
Does anyone know of a standard stencil thickness for BGA'S. We currently use 4 to 5 mil stencils depending on component mix. Is an aperature reduction required for BGA'S. If so what percentage. Any help would be greatly appreciated. Thanks MRMAINT
Electronics Forum | Mon Oct 13 19:04:47 EDT 2003 | davef
Aperture size should vary with the component [pitch]. That size should be the same a the pad size. So, generally pinching is not required. Indium discusses BGA apertures on their site [ http://www.indium.com ]
Electronics Forum | Thu Aug 12 10:49:22 EDT 1999 | Ray Hare
I am currently involved with designing a pcb which will use 225 pin bga,s The problem with this design is that the components will dissipate a lot of heat and the design we have come up with is use the middle 6 or 7 rows of balls as the grounding,th
Electronics Forum | Thu Aug 12 17:15:56 EDT 1999 | Jim Blankenhorn
| I am currently involved with designing a pcb which will use 225 pin bga,s | The problem with this design is that the components will dissipate a lot of heat and the design we have come up with is | use the middle 6 or 7 rows of balls as the ground
Electronics Forum | Fri Aug 13 04:12:41 EDT 1999 | ray hare
| | I am currently involved with designing a pcb which will use 225 pin bga,s | | The problem with this design is that the components will dissipate a lot of heat and the design we have come up with is | | use the middle 6 or 7 rows of balls as the
Electronics Forum | Fri Aug 13 05:38:45 EDT 1999 | stefano bolleri
Ray, what about allowing everybody else to know about the "more info" ???? This is supposed to be a forum, isn't it? Bye, SB | Thanks for the reply, | i have sent you an e mail with more info in it. | thanks ray hare
Electronics Forum | Wed Feb 22 08:02:56 EST 2006 | dj44
I was looking for an stencil design for a 0.5mm pitch uBGA. Pad size is 0.38mm in diameter. We have been using 5mil stencil with type 3 no clean paste. What size aperture should we be using? Any suggestions?
Electronics Forum | Mon May 15 15:42:29 EDT 2000 | Doug Smith
Can anyone tell me a recomended stencil apt. design for PBGA's and Ceramic BGA's when using a no clean (UP78) paste?
Electronics Forum | Wed Feb 22 10:00:58 EST 2006 | dougs
We've just set up a couple of products with 0.5mm pitch uBGA devices on them, i went for 5thou thick, laser cut nickel (to aid paste release) square pads same size as the diameter of the uBGA pads. Or you could go to a 4 thou nickel stencil, better
Electronics Forum | Wed Feb 05 14:20:45 EST 2003 | Stephen
One thing that worked for me was simply rounding off the pads, making square pads into circlesfor the stencil. It worked but did seem a little strange turning squares into circles for 0603's and 0402's and turning cirlces for BGA's into squares, (bu
winsouce.jpg)
