Electronics Forum | Fri Oct 14 19:41:06 EDT 2005 | KT
We encounter this kind of issue. We use stencil clean in the stencil printer and also use air to blow aperture after cleaning. We are having some luck !!
Electronics Forum | Mon Feb 23 12:22:32 EST 2004 | esoderberg
I have an MPM SPM and two Ekra E4 screen printers. I have always run them dry with vacuum. I am also using no-clean paste and have not had a problem. The volume I run per day on the machines is 4 - 6,000 bds
Electronics Forum | Wed Jan 13 20:44:42 EST 1999 | Steve Gregory
Hello Sanjay! The cheap deal I use that Earl spoke of is called a SMarT Measure. It's a depth measuring microscope that uses the same principle of measuring optical focus that the units from Vision Engineering do ( if you've ever looked at any
Electronics Forum | Thu Jan 14 15:22:14 EST 1999 | Earl Moon
| Steve, | Whoa, take a breath! That was at least a dollar three-eighty answer. I've got to agree that nothing can replace a qualified, concientious operator for assuring quality. When I too worked at a small shop there in SillyCone Valley, my
Electronics Forum | Thu Jan 14 11:08:29 EST 1999 | Mike McMonagle
Steve, Whoa, take a breath! That was at least a dollar three-eighty answer. I've got to agree that nothing can replace a qualified, concientious operator for assuring quality. When I too worked at a small shop there in SillyCone Valley, my seni
Electronics Forum | Tue Oct 11 10:49:14 EDT 2005 | jhagve
HI We start to make a product which have a 0.4 mm pitch IC and start having problems with not enough solder printed, to solve this problem we had to increase the manual cleaning, now we are cleaning the stencil every 8 printings, before we was runnin
Electronics Forum | Fri Mar 29 04:06:42 EST 2002 | bayanbaru
Is there a cheap and effective method for stencil cleaning? Getting a equipment is out of the question.
Electronics Forum | Tue Apr 02 13:35:02 EST 2002 | Mike Konrad
Hi Dave, God no! I am not suggesting that anyone should clean stencils by hand. My answer was facetious. The questioner asked is there was a �cheap and effective� way of cleaning stencils without purchasing equipment. Cleaning stencils by hand m
Electronics Forum | Fri Oct 21 14:13:08 EDT 2005 | mafc65
1.- Clean bottom and top stencil with a cloth/alcohol at same time.Pay special attention to fine pitch locations. 2.- Clean again bottom stencil side .To prevent any residual of solder 3.- Blow air with a air gun under the stencil to remove the solde
Electronics Forum | Thu Dec 06 20:58:53 EST 2001 | chinaren
Hello,everyone: Would you like provide me some information about the equipment you use for the stencil cleaning and the solvent that is effective or you are satisfied with the cleaning result? best regards
.gif)
