Electronics Forum | Wed Apr 25 10:15:06 EDT 2012 | cyber_wolf
Does anyone have a source for micro cross section supplies? I know about Buehler...was looking for another.
Electronics Forum | Wed Apr 25 12:16:09 EDT 2012 | markhoch
You might want to take a look at Allied High Tech. I was investigating this same thing a few years ago. I never purchased it, so I can't vouch for the product itself, but it's another option. http://www.alliedhightech.com/grinding/xsectiontool/
Electronics Forum | Wed Apr 25 13:45:41 EDT 2012 | davef
Failure analysis, Cross section Cross section equipment sectioning equipment suppliers: * Leco; 3000 Lakeview Ave, St. Joseph, MI 49085; leco.com * Struers; 24766 Detroit Rd, Westlake, OH 44145; 888-787-8377 F440-871-8188 struers.com * Buehler Worldw
Electronics Forum | Tue Nov 29 11:45:35 EST 2016 | ttheis
I was able to repair the original power supply for the printer again with parts from another similar power supply on ebay. At first the machine didn't power up properly even though the supply voltages were all good on a volt meter when tested befor
Electronics Forum | Sun Nov 27 16:53:39 EST 2016 | ttheis
Our UP500 has been running great for a few months then the AC/DC 5/12/24V power supply stopped working and the PC could not communicate with the cage. The PC screen also got very noisy. We replaced the power supply with a used replacement and the ma
Electronics Forum | Thu Dec 01 13:35:21 EST 2016 | ttheis
I decided to replace the psu with three din supplies since it was a repeatable issue with the 5v rail. Machine is back in operation now with no signs of problems.
Electronics Forum | Wed Nov 30 20:43:06 EST 2016 | ttheis
OK, so went to power up again today and had the same kind of issues. The 24V and 5V lights on the cage flicker dimly about every 500ms. I tried my trick of disconnecting the +24v lead to the lift table amp and it acted the same, so it didn't work th
Electronics Forum | Mon Sep 17 18:12:54 EDT 2007 | sarason
Then look for a disconnected supply or earth to the head. A dodgy cap (high ESR) on the supply of the board. Put a CRO on the supply and check it's supply and earth to chassis and to each other and then compare the level to other boards in the machin
Electronics Forum | Wed May 19 17:54:41 EDT 2010 | gregcr
I have had problems corrected by swapping or replacing the power supplies in the box. Do you have a second GSM that runs the AIS3500 box? If so swap the power supply and see if the problem follows the swap. I have replaced the supplies inside the
Electronics Forum | Fri Aug 05 23:52:34 EDT 2016 | lilybell
I'm making some PCB's that have some DC to DC converters on them with three 5 Volt converters, one 15 volt converter, and a converter with +/- 12 volts DC. On the PCB the output pins are in a connector that are fairly close to each other. I want to m