Electronics Forum | Fri Mar 30 07:14:42 EST 2001 | pteerink
Genny, Xray systems ( or at least what I have seen ) are a manual based system. That is, you put the board on the machine and look at certain locations that you want to inspect. What we have in mind is an automated system that will catch obvious, no
Electronics Forum | Fri Mar 30 07:14:51 EST 2001 | pteerink
Genny, Xray systems ( or at least what I have seen ) are a manual based system. That is, you put the board on the machine and look at certain locations that you want to inspect. What we have in mind is an automated system that will catch obvious, no
Electronics Forum | Thu Mar 29 08:23:02 EST 2001 | CAL
Some AOI manufacturers require you to put in a GOLD PCB. Gold PCB is a perfectly manufactured board - Correct placements, correct polarity, no solder short, a "GOOD" PCB. With the vision limitations of some AOI equipment components that have variatio
Electronics Forum | Fri Mar 30 07:24:43 EST 2001 | pteerink
Have you had bad experiences? We have a paste checker on line, and all components are verified at receiving and again when loaded on the machines. The purpose of AOI ( for us anyway ) is to reduce the time spent after reflow visually checking the b
Electronics Forum | Thu Mar 29 10:51:47 EST 2001 | Deon Nungaray
Hello Phil, AOI equipment has been around for a number of years. I remember evaluating a machine around 5 years ago. At this time the system was not able to learn right side up or upside down characters. Well, the newer systems have come a long way.
Electronics Forum | Fri Mar 30 11:04:24 EST 2001 | genny
We are already using ICT on the PCB, which should catch most missing components, also components installed backwards, or the wrong value(to a point - we do RF so we have lots of very small value caps and inductors which can't be measured), and in som
Electronics Forum | Wed Dec 04 16:35:54 EST 2013 | martingruber
I am facing the following problem: Powering up the machine the start sequence stops with following message: Inizializing Hardware .... Reading SRAM data .... Inizializing MEI Motion Bd .... Mei bd. @ 240 # Dev. Version 2.4g2 Option 41 DSP BOOT MEMORY
Electronics Forum | Fri Sep 14 08:53:43 EDT 2012 | mbnetto
Hi, Recently we acquired a Delta 3 and I noticed everytime we change any value regarding to the tracking system, as chip or main wave - offtime/ontime- with boards loaded on it, the tracking system doesnt work well. sometimes it turns off the wave o
Electronics Forum | Wed Aug 18 13:48:12 EDT 2021 | rgduval
It's been awhile, but, some other things you might look at: - Check the fiducials on the toolbox. If they're getting obscured/damaged, all kinds of weird things can happen. I had problems initializing tools one time because of this, and I could actu
Electronics Forum | Tue Feb 24 08:41:42 EST 2015 | leeg
We are getting a position board system error more and more just lately on a FX1 that we have, anyone seen this error before ?
winsouce.jpg)
