Electronics Forum | Fri Feb 19 11:13:02 EST 2016 | ttheis
I'm setting up a product for the first time on my GSM after I completed debugging some other issues. The previous owners had the PWC axis disabled and the axis motor disconnected, so I re-connected it and enabled it and now it homes and moves. When I
Electronics Forum | Tue Oct 01 18:44:24 EDT 2013 | richardconnell
Hi, I have limited capability on the Z axis. The axis will home to the mechanical switch limit and then drop to a point which I asssume to be the fiorst zero point below the mechanical switch limit. Then it gives the error. There is power to the mo
Electronics Forum | Thu Mar 02 19:54:51 EST 2023 | oxygensmd
The question is, the motor is working or not? Moves, does anything? Seems to be endswitch not working if moves and you heard beaming sound - like motor moving but its on mechanical endpoint. If I were you, I bet on a limit switch is defective under
Electronics Forum | Tue Feb 28 22:32:38 EST 2023 | cbeneat
it looks like the table is in contact with the Y1 switch. If you can remove the cover, the motor is the R/H one. Turning the belt will move that side of the table. I'm going with the assumption that an X4 is close to an X5.
Electronics Forum | Wed Sep 22 13:49:47 EDT 1999 | Claude Couture
The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table move
Electronics Forum | Fri Sep 24 13:44:06 EDT 1999 | Eric Lee Williams
| | The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table
Electronics Forum | Tue Nov 01 09:36:41 EDT 2011 | emeto
THe question is - does that happen on all of your programs or just in one program? If it is just this particular board, it might be some softwaRE limit issue. If it happens on more programs it is a hardware issue and it could be one of the following:
Electronics Forum | Fri Sep 24 10:43:42 EDT 1999 | Ken Kkoyen
| The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table mo
Electronics Forum | Mon Mar 18 11:04:39 EST 2002 | slthomas
At a previous employer we used a pneumatic dental type drill with nice results. The 1/4" hose is much more flexible than a flex drive cable, there's no motor module on the work surface, and the foot pedal for the air a little more elegant than two-h
Electronics Forum | Wed Jun 08 13:16:02 EDT 2005 | cyber_wolf
It sounds to me like it may be your squeegee Z motion controller card. The SQUEEGEE Z motion controller card is interchangeable with some of the other motion cards in the back of the machine.(NOT ALL OF THEM) Make sure you look at the power ratings a
