Electronics Forum | Fri Dec 17 09:49:34 EST 2010 | remullis
Hello to all, I am having problems with the X,Y table initializing. I noticed the Skew motors 17M1 and 17m2 are moving but the table keeps wanting to drive in the left direction standing in front of machine. It will keep trying to drive until it tim
Electronics Forum | Mon Dec 20 04:41:38 EST 2010 | accuspares
Hi, The input indicators can be located by selecting the 'Input' page located in the 'Diagnostics' drop down menu. Just select the Align tab at the top of the page and you'll be able to see when the nearly home and home sensors change state. The pr
Electronics Forum | Mon Dec 20 10:53:41 EST 2010 | remullis
I started swapping motor cables and sensor cable doing a process of elimination and never found a problem, I put everything back to original and it homed. I not sure if it was a connection issue or it was a sequence of homing the machine needs to do
Electronics Forum | Mon Sep 21 00:11:14 EDT 2009 | darrenj
We have a TP9 with a centering motor issue. (TPSYS Ver 2.5.3) The error message F-MOT-SETDYN C/3 Upper endpoint outside limits is shown during C-motor initiation. I've looked in the service program and also the parameters in TPSYS but can find no m
Electronics Forum | Thu Aug 17 13:55:45 EDT 2023 | markhoch
I think we need more information. Is it moving at all? Does it move to a reference position and then stop before returning to the home position? Have you verified that all sensors are working correctly? Does the machine use stepper motors, motors & e
Electronics Forum | Thu Jun 10 22:13:01 EDT 2021 | roycet4
I would start by replacing the Z axis motor for head #4, you previously mentioned there was also a theta axis issue with head #4, you might be best served to replace both motors. These motors do go bad from time to time, We have 28 Juki machines wher
Electronics Forum | Thu Aug 17 14:35:47 EDT 2023 | lauri
Thanks for the response. We have checked everything except the stepper motor, which we will try. But as we were checking everything now we've developed a software (?) problem. A msg comes up "can't find DSP".
Electronics Forum | Mon Feb 22 10:19:57 EST 2010 | swag
Check/reseat all connections on axis driver card and from driver card to step motor. On older MpM's it is common to get a bad connection on the connector for axis driver power and blow components on your driver board. Reseating these connectors mig
Electronics Forum | Fri Oct 13 10:36:51 EDT 2023 | barty
Hello! To download TikTok videos and then watch them without internet access, https://savetiktok.org is the perfect solution. This service allows you to download videos and save them to your device, allowing you to enjoy the content even where there
Electronics Forum | Mon Apr 19 16:07:32 EDT 2021 | sacd
Hello. When I am originating machine Juki KE20060RL Error On Initializing appear Z4-axis. The position error exceeded the limit. I am check and diagnosed that motor Z don't move at all. Attached axis monitor shows the current state of the axis . Coul
winsouce.jpg)
