Electronics Forum | Wed Feb 15 14:03:25 EST 2006 | samir
Robert McKeown Company makes thermally conduct Al tape. KIC did a study on which method (Kapton Tape, Aluminum Tape, Hi-Temp Solder) is the most repeatable. The study can be found in their website: http://www.kicthermal.com Al Tape placed 2nd, and
Electronics Forum | Thu May 04 12:02:37 EDT 2017 | tombstonesmt
Splice in carrier tape left over or purchase leaders from suppliers like Sierra. http://tapesplice.com/product-category/flat-punched-carrier-tape/
Electronics Forum | Wed Sep 27 16:54:30 EDT 2000 | LarryK
We currently use Kapton tape to cover a display. The only real purpose for this tape is to cosmetically protect it thoughout the process. The display gets hand soldered and washed, so the idea of the tape being high temperture isn't a factor. Becaus
Electronics Forum | Fri Oct 21 08:19:15 EDT 2005 | Jim
We are experinecing adhesives left on the boards after running taped boards for placement verification on NPI. We've been using 3M double sided (333) tape for over 15 years. Any other suggestions on a good tape to use? This may be a quality issue
Electronics Forum | Wed Sep 27 19:57:41 EDT 2000 | Dave F
Our display suppliers provide displays either with: * Molded plastic cover that we recycle to them * Plastic film like the guys that change your oil put on your wind shield to remind you when to get your oil changed.
Electronics Forum | Thu Mar 30 13:15:17 EST 2006 | gregp
Maybe the issue is how the feeders are being unloaded. The operators should leave enough covertape to reload the reel onto a feeder without component waste. If the issue is some parts are exposed in the feeder then you will most likely loose those p
Electronics Forum | Wed Dec 13 12:08:57 EST 2000 | Stefan Witte
Apparently the adhesive tape peels off from the joint, which could have some reasons. 1. There should be an overlap of the cover tape, as Cal mentioned. The new cover tape laying over the old by approx. 2mm. I also peel the cover tape a bit off, whi
Electronics Forum | Wed Sep 21 12:30:03 EDT 2005 | Rob
Hi Greg, We've used lots of machines over the years & seen lots of different tape related issues - the main one being snap off of the cover tape, usually due to too much glue, over entusiastic heat seal, or a feeder requiring maintainance. Also the
Electronics Forum | Sat Aug 18 23:03:07 EDT 2012 | eadthem
We have had this problem in the past, On paper tape resistors(old stock from before i took over and forced rotation on everything) and on embossed (national semi parts, strings of glue pulled back like seat belts across the pocket.) For the national
Electronics Forum | Thu Mar 30 13:53:53 EST 2006 | PWH
We've had poor luck with leaders - inefficient, not cost effective for the price of the parts usually. In my opinion, your best bet is to over-issue parts to a scrap # that works for you (all feeders are different as are machine scrap rates). This
.gif)
winsouce.jpg)