Electronics Forum | Wed May 15 12:53:19 EDT 2013 | mchawg
I am having difficulty programming/inspecting a large SMT Relay. It is a dual in-line through-hole package with 5 leads per side formed to a gullwing configuration on .100" pitch. We have programmed it as a SOW10 pkg and got usable lighting values bu
Electronics Forum | Fri Nov 25 11:55:22 EST 2022 | poly
So I'm attempting to run feeder teach for my platform tray feeder... but I've got no idea what first point I should teach is... normal is the end pin of the feeder but this is for the ptf conveyor... so I've got no idea. If I just teach each corner
Electronics Forum | Sat Dec 10 08:26:14 EST 2022 | poly
That procedure all works perfectly, and I'm read through that section of the manual however... 12. Perform Feeder Teach. Refer to the Feeder Teach Voyager help topic. I can't find anything in Voyager that explains the feeder teach procedure for t
Electronics Forum | Wed Mar 03 13:33:25 EST 2004 | stefwitt
How well should the fiducial be centered in the teach mode? Consider that you see the fiducial with probably 40 times magnification on the monitor. If you see the cross-hair a bit off center, then this is most likely just by a few hundreds of a milli
Electronics Forum | Wed Jun 15 00:33:11 EDT 2005 | Frank
You didn't state if you are using all CAD data or not. If you are not using any CAD data then all bets are off. If you global fid XY data and all your placement XY data are all from CAD data, but you are manually teaching your local fids, then they
Electronics Forum | Fri Jun 10 21:22:36 EDT 2005 | KEN
JD, fiducials are merely land marks. The vision processor will measure the actual location and compare it to the CAD location. It does not care if the design is symetrical, asymetrical or what. In the case of a single center design fiducial (which
Electronics Forum | Thu Aug 21 19:18:47 EDT 2008 | duchoang
My steps are different in that case: 1- Check mounts. Try to adjust origin point until get the pretty good mount positions. 2- Teach fiducials ( Board fids, not panel fids) 3- Use fids, check mount again. 4- If OK, then teach Block Repeat. This alwas
Electronics Forum | Tue Aug 19 13:35:51 EDT 2008 | stefi
Hello, I need an advice regarding the next issue: in the case of Assembleon Topaz or Emerald SMT machines, is there necessary to teach first the block repeat coordinates and after that the PCB fiducial coordinates when you do not have these coordina
Electronics Forum | Fri Aug 22 15:27:13 EDT 2008 | wayne123
this is the order that I use. 1. Teach pcb origin 2. Teach fiducial location 3. dial in vision on fid in mark info. 4. go into mount and verify that the primary image is on in x/y (after perfoming a teach trace condition) and then do any offsetts if
Electronics Forum | Sat Dec 03 01:07:29 EST 2022 | poly
I've got access to the universal manuals / voyager but I haven't found a section that describes the feeder teach setup process, I can pick up the teach slug onto the conveyor and then get into feeder teach but if I teach the corners of the slug as t
