Electronics Forum | Fri Dec 15 11:24:54 EST 2023 | dimamalin
Hello! I want to inquire about settings for MPM printers with the Camalot inside system. We will use Koki JU-R45 adhesive and Koki S3X58-M406-3 solder paste with a 21ga needle. If anyone has a similar system, could you please share the initial parame
Electronics Forum | Thu Oct 23 04:19:15 EDT 2014 | garteaga
Our reflow oven builds solder on one specific panel type. It will have solder buildup inside the oven. We then end up with small solder balls on our panels. We think it may be the solder paste, the screen printer is leaving a clean wipe under the pa
Electronics Forum | Thu Oct 23 09:45:05 EDT 2014 | rgduval
Generally, excess solder balls found randomly around the board/parts points to either a dirty stencil during printing, or a stencil/board that is shifting during printing (smearing the paste a little, and causing a dirty stencil. If the apertures ar
Electronics Forum | Wed Sep 05 16:35:22 EDT 2012 | davef
It depends, but I'd guess that as a minimum the floor clock will start when the component returns to room temperature. It's easy to argue that the floor clock starts earlier than that!!! Probably, the floor clock starts a couple degrees lower than th
Electronics Forum | Wed Apr 26 19:10:43 EDT 2023 | cyber_wolf
This machines support table looks similar to AP and UP machines. I believe MPM published the dimensions of the "H" tower that the dedicated plates bolts to. As far as the plate, they are typically (2) pieces with the inside hollowed out to allow for
Electronics Forum | Mon May 13 12:50:35 EDT 2019 | robl
Hi Spoiltforchoice, it depends on what you pay for the printers new, but last time I looked there wasn't much difference in price between the DEKs and the Speedprint if you were buying multiple units. Remember there is huge markups on SMT kit. From
Electronics Forum | Mon May 12 11:36:35 EDT 2008 | cyber_wolf
Harry,I know what you mean. You are completely right and justified. My father owns his own business and I see stuff like what you described all of the time. Yes we have done business before. I worked with you when you were with MPM and after you st
Electronics Forum | Mon Feb 16 16:23:32 EST 2004 | blnorman
We tried Ionox BC in our MPM, but evidently a feed line came loose allowing the Ionox to spray, flood, whatever on the inside of the machine. The Ionox ate through some of the insulation on the wires. As long as it stayed in the plumbing, it worked
Electronics Forum | Wed Oct 14 22:25:57 EDT 1998 | Jason
Jim, To my understanding this printer is formerly known as an SMTech printer. The story behind this printer, from what I was told by former colleges, is, open it up, take a look at the inside. Does it look like a DEK 265? I hear that this printer
Electronics Forum | Fri Jan 10 04:42:14 EST 2020 | richardcargill
SOLVED !! Booting up into DOS there's a file called optedt.exe in the AP folder. This is the option editor. It's password protected when you run it, but a quick look inside the code solved that one. QMPM gets you in if you need it
winsouce.jpg)
