Electronics Forum | Wed Sep 12 10:49:46 EDT 2012 | cyber_wolf
Sounds like the feed cylinder sensor. Its a air cylinder hooked to the tape feeder advancing mechanism in the rear of the machine. Go into the I/O and make sure the sensor is changing state when you flag it.
Electronics Forum | Mon Sep 10 12:18:05 EDT 2012 | benreben
Hi, what's the feeding sensor error? the sensor for cartrige or the sensor on cylinder up of feeder? manual is step mode? if you have the number of error at screen,i have the fuji error code help. in step mode the machine is very slowly,maybe the a
Electronics Forum | Sat Sep 08 23:36:14 EDT 2012 | mtech88
Can anyone help me out this Fuji CP4 problem? I just move my machine to a new place, The feeding sensor error keep on poping up. but the mahine work on manual mode. When we switch to auto mode, it just to pick up the part and the machine stop on t
Electronics Forum | Wed Sep 12 12:41:53 EDT 2012 | cyber_wolf
You probably have a component that you are telling to advance twice.
Electronics Forum | Wed Sep 12 11:52:31 EDT 2012 | mtech88
Ben: you are right, I think the timing must be off some how. I will check the error code and post it back here. thanks David
Electronics Forum | Wed Sep 12 11:55:18 EDT 2012 | mtech88
Sr. Tech: I will check the air cylinder at the rear and see what position when the machine stop. Thanks David
Electronics Forum | Fri May 13 02:43:21 EDT 2016 | karts22
Hi, We have several fixtures for GenRad 228x tester and would like to change sensor plates as they are quite worn. The problem is that 3 fixtures have different plate sizes for the same IC, side length is 10-12mm. What would be the best size for sens
Electronics Forum | Wed Jun 20 18:32:35 EDT 2001 | davef
I'm sorry, I can�t image on your words. A couple of years ago, we had a rash of DOA shipments to a customer. We thought someone could be drop-kicking the packaged product down the stairs. So, we shipped with BIG red labels and impact indicators on
Electronics Forum | Wed Mar 13 14:17:03 EST 2002 | dougt
Are these sensors the reflective type? Maybe when the board is unclamped and it goes over the sensor it is seen, and then when it is clamped (raised) it is now out of the range the sensor was set for. That should be easy to adjust. A problem I've
Electronics Forum | Tue Mar 19 16:55:54 EST 2002 | Steve E ( Fujiamerica )
This problem happens when a dark part is placed where the main conveyer stop sensor is located.The machine does a board check ( back to loading pos ) . If a part is under the sensor it absorbs the beam and the machine thinks there�s no board. The ta
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
