Electronics Forum | Mon May 11 17:03:05 EDT 2015 | dilogic
Any advice how to (easily) replace theta timing belt on GSM Flex head?
Electronics Forum | Wed Jul 03 06:52:27 EDT 2019 | bobpan
Seems to be fighting to hold its position. 1. Check for anything worn out...possibly idler bearing/pulley and/or the belt. 2. Maybe it could use servo tuning...this may help but usually servo tuning is not that critical. 3. Clean the scale and the
Electronics Forum | Sat Apr 23 00:21:10 EDT 2011 | azrina
As am doing screening right now, am not measuring the total cleanliness yet, i just observe by taking photos (FYI, am varying speed for conveyor belt for cleaning) and see whether the flux is able to be removed by certain parameters. the speed am usi
Electronics Forum | Wed Apr 21 21:47:46 EDT 1999 | Steve Gregory
| HELP | I need any information on how to purchase "Metal baskets" | (dimensions 3" height x 18" width and length) for our HUGE cleaning machine for our PCBA's. Pleas eif anybody could give me sales info, or company information it would be greatly a
Electronics Forum | Wed Mar 30 22:47:42 EDT 2022 | SMTA-64387687
Check the Theta belt. Is it clean, not worn, no kinks? Are the tools rotating freely?
Electronics Forum | Thu Mar 31 11:13:33 EDT 2022 | jzeivel
I forgot to mention in my original post, I actually replaced the theta belt and cleaned the head. All the tools rotate as they should. When I run the burn-in I get no errors. I can run the "test sub-systems" on the head in the service program and
Electronics Forum | Wed Sep 11 18:01:27 EDT 2013 | huske
I've had that issue before, here's how you fix it, or at least it worked for me. Also assuming you didn't destroy a shaft, which should be obvious. Follow the flexible vacuum tubes to the top of the hydra shafts, you should see a red light below the
Electronics Forum | Tue Jan 26 08:57:01 EST 2010 | Jeff
Check your belt tension on the theta motor.
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Wed Nov 16 18:20:39 EST 2011 | dontfeedphils
According to the message guide it just says that it's a error telling you to initiate the Hydra Theta axis. I suppose the encoder for the hydra theta motor could be losing count and causing it to need to be re-initiated, or it could be something to