Electronics Forum | Mon Oct 13 19:04:47 EDT 2003 | davef
Aperture size should vary with the component [pitch]. That size should be the same a the pad size. So, generally pinching is not required. Indium discusses BGA apertures on their site [ http://www.indium.com ]
Electronics Forum | Mon Oct 13 13:49:29 EDT 2003 | mrmaint
Does anyone know of a standard stencil thickness for BGA'S. We currently use 4 to 5 mil stencils depending on component mix. Is an aperature reduction required for BGA'S. If so what percentage. Any help would be greatly appreciated. Thanks MRMAINT
Electronics Forum | Thu Jun 22 10:27:26 EDT 2000 | Igmar
Can someone please help with the aperture size on a Micro BGA stencil. I want to have an electroformed stencil made with 0.1mm (4mil) thickness. The PCB pad for the micro BGA has a 0.406mm (16mil) diameter. What size should I make the apertures for t
Electronics Forum | Fri Jun 23 09:54:20 EDT 2000 | Dave F
Igmar: Chrys and JAX make good points. I'd like to add that you should be careful that you don't starve larger chip components of solder when using a 4 thou stencil.
Electronics Forum | Thu Jun 22 11:21:59 EDT 2000 | Chrys Shea
My personal opinion: Use 20 mil squares with the corners radiused at 5 mils. The squares offer 2 benefits: 1) A little more paste, which makes for a higher diameter solder column that is more reliable 2) Better stencil release of the paste. It's e
Electronics Forum | Thu Jun 22 12:50:13 EDT 2000 | JAX
Igmar, Although I agree with Chrys that square is good,( Better volumn ) his explanation is not entirely correct. Heres a little insert from automata: With square apertures, solder paste is deposited at the center of the aperture. The center release
Electronics Forum | Fri Jun 30 10:42:24 EDT 2000 | Chrys Shea
That pad had a 16 mil dia, so I arrived at 20 mil squares by adding 2 mils to each side of the pad. Following that logic, a 12 mil pad would use a 16 mil square. But a 12 mil pad is on a finer pitch that isn't mentioned, so you should definitely
Electronics Forum | Thu Jun 29 09:29:46 EDT 2000 | JAX
sree, You might want to check the archives. If not, I found this just a few questions below yours!! [Back to thread listing at top] Posted by Igmar on June 22, 2000 at 10:27:26 AM EST Can someone please help with the aperture size on a Micro BGA st
Electronics Forum | Thu Jun 09 07:02:02 EDT 2005 | ajaydoshi
1. We do have PCB with 0402 component, Micro BGA ( 0.5mm pitch , 0.25 mm pad size ). PCB thickness is 0.8mm. What stencil thickness we should use. PCB size 40 mm X 60 mm 2. We have EKRA E4 , What will be optimum setting for above. Pressure, Scquge s
Electronics Forum | Fri Apr 11 06:22:04 EDT 2008 | andrzej
Hi Andrzej, > > We are using for BGA (0.8 pitch) > square apertures size 0.4 mm (rounded corners r = > t) and stencil thickness t=5 mils. So area > ration-_ w/4t=0.8 > > Regards Jan Hello Jan, I understand that you have the same pad dimensio
winsouce.jpg)
