Electronics Forum | Wed Jun 18 02:43:37 EDT 2014 | tjbooc
CHECK IO BOARDS STATUS, CHECK HEAD IO 24VDC SUPPLY, CHECK 24VDC SUPPLY TERMINAL, CHECK WIRING CONNECTED TO HEAD IO I think this is an I/O communication problem. Fail in connecting to I/O cards.
Electronics Forum | Tue Jun 17 10:46:16 EDT 2014 | bestglobalsmt
When the machine loads up it gets to the 2nd to last step where it starts to load vacuum data - we get 4 pop up windows once that fails. Ea2510 Machine Start error - Machine cannot be started Es00212 APPL CPU Haandshake error Ea2504 I/O Data trans
Electronics Forum | Wed May 06 20:52:26 EDT 2015 | arbpkevin
I have been using my topaz X for about 4 years now and I feel that I am fairly knowledgeable about it, at least the functions of it that I use... I am trying to use the LCS to place some qfp chips on a new product and I have set the whole thing up t
Electronics Forum | Wed May 13 12:39:25 EDT 2015 | arbpkevin
Ahh, yes. Just about the same time you replied someone else I asked said the same thing! I didn't realize that you had to put the part on by hand for the vision test. In the book it says to leave the feeder position set to the default setting. Fu
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Fri Mar 06 19:32:09 EST 2020 | SMTA-Alex
The fact, that your Hydra head goes up and then starts moving slowly, means that it didn't find the limit. Since there are no mechanical obstructions and you swapped all the boards, the things to look at are cabling. Double check the ribbon cables fo
Electronics Forum | Tue Feb 09 09:18:13 EST 2010 | davemacnemo
Machine installer gave me some tips and a run through the software. Everything worked just fine. First solo attempt to run product that we started with gives L305 SoftLimitOver... error after picking first components and passing over camera. Additio
Electronics Forum | Sat Oct 06 15:00:42 EDT 2012 | chrisnims
We bought a used 1999 topaz x and are trying to get it up and running. unfortunately we are getting an error: Anyone know where i can get a service manual or having any idea where to look to resolve this problem? "E229" “Nozzle down limit sensor is
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Mon Oct 17 13:02:28 EDT 2016 | tdemon69
i have a MPM2000 now giving me 0 - hardware limit warnings..let me start off by saying that is was giving me x axis limit problems, so i replaced the x card with diff card. set all the switch and jumpers to x card , then i got 0- hardware . so then
