Electronics Forum | Mon Jun 23 19:33:09 EDT 2008 | adamcrum
Hello, I have a Philips Assembleon Topaz (not an X or XII, just Topaz), that we got from a broker or what have you. I just did a complete rebuild of the head assembly after some of the shaft bearings went out and was getting ready to do the auto moun
Electronics Forum | Thu Dec 22 13:36:29 EST 2011 | toddl
Hi all, the company I work for is looking to have our MV series machines calibrated. Is there a service tech available (other than from Panasonic) in the northern US or preferably in Canada able to perform a full calibration? Please send me any feedb
Electronics Forum | Tue Sep 30 19:48:14 EDT 2008 | snsmt
I have a block programmed and i want the machine to just do one block at a time instead of doing the whole panel (each panel has 56 PCBs) at once and skipping around. how would i do that? thanks in advance steven
Electronics Forum | Thu May 29 22:06:24 EDT 2014 | proy
Hi You might want to join and post this on my Yahoo Assembleon users group, it is new so we only have 6 or so members, but as it grows it will be more and more useful. My 2c worth is that a sapphire might be kind of old and problematic for support
Electronics Forum | Mon Oct 14 15:48:37 EDT 2002 | pjc
If you are concerned with the actual temp of your pre-heater verses what the machine's display "says" the temp is, use a calibrated digital thermometer and place the thermocouple probe inside the pre-heater and next to the machine's thermocouple for
Electronics Forum | Fri May 27 13:20:06 EDT 2016 | elton111
how are you. I have a problem with a table that the issue errori topaz. The issue is the message "Bring back component." a problem with the pick up parts vacum setting level is 100 and the current 111 with vacum head is 6. Can u tell me how to Calibr
Electronics Forum | Tue Oct 15 10:15:47 EDT 2002 | pjc
Sue, It may be a thermocouple problem or the PID heater controller. Check with the wave machine mfg.'s tech support.
Electronics Forum | Thu Mar 29 08:22:41 EDT 2018 | ushir
Hi all Does anyone here have any experience in calibration of iPulse machines? (M10, M20, M4, M7). We would like to correct camera and placement offsets. I believe this is done through AMF, but wanted a bit more information. Thanks
Electronics Forum | Sat Nov 17 10:24:17 EST 2007 | etienne
Hi, I can give my opinion in this topic since I worked with both machines. To say the truth, I would recommend neither machine. First of all, operating software is much quite the same for both machines. The TP9 is true that has a larger footprint ov
Electronics Forum | Wed Nov 21 13:42:12 EST 2007 | etienne
To answer your question: During my experience with Topaz machines, we had to replace 4 Heads on different occassions with different operators involved. Also I encountered several Head crashes with Eclipse machines. To buy such replacements here in Ma
