Electronics Forum | Fri Feb 22 10:46:04 EST 2008 | mulder0990
Yes, we have. We do have one machine that can place the 0201 parts. I have bought some 0.4mm tape leaf covers and replaced the 0.7mm covers on some CP6 0802 feeders. I calibrate the feeders as tight as I can and make sure the feeders that we use a
Electronics Forum | Sat Oct 12 05:05:09 EDT 2002 | Kenture
I run 0201 on a 5 mils stencil with openting of 15X12 and did not have any issue. The major concern is the placement and CP643 did very good job. Type 3 solder pastes was used. Good luck.
Electronics Forum | Fri Sep 02 07:38:13 EDT 2005 | DannyJ
Hi Mike, I haven't tried the 0201s with a Hyrda, but after seeing 20 reviews of your message without a response, I'll try and share my experience with 0402s on a non-Hydra machine. The 0402s are slow, but I managed to get some speed by maxing out
Electronics Forum | Fri Jul 29 19:12:30 EDT 2005 | Jason Fullerton
In the true sense of the term, tombstoning can only occur during reflow. Now, if your solder joints are cracking during thermal cycling and opening on one end you still have a problem - it just isn't "tombstoning". What laminate are you using on yo
Electronics Forum | Tue Feb 26 16:07:07 EST 2013 | kevslatvin
What vintage are the gem series you are running? We have some '06 Opal Xii's and place 0201's with them. Haven't tried 01005's. I know you said new but Cardinal Circuit has an auction gonig right now that has a 2010 Assembleon MG1 and a 2006 MG2 and
Electronics Forum | Mon May 13 19:47:37 EDT 2002 | bcceng
Mladen, I am in contract manufacturing using the regular Philips Topaz. I started with one now I have four, if market ramps up will be getting more. The Topaz regular can place 0201,BCC,BGA's,Micro BGA's and others depending on the configuration of
Electronics Forum | Tue Aug 23 15:27:38 EDT 2005 | Frank
I know this post is getting a bit old, but the Juki KE-2060 can do 0201 up to 74mm square (or up to 150mm long connectors) on their standard machine. You only need to purchase the 0201 nozzle and feeder. The machine is factory set to run 0201. And
Electronics Forum | Sat Oct 06 15:00:42 EDT 2012 | chrisnims
We bought a used 1999 topaz x and are trying to get it up and running. unfortunately we are getting an error: Anyone know where i can get a service manual or having any idea where to look to resolve this problem? "E229" “Nozzle down limit sensor is
Electronics Forum | Fri Dec 10 02:49:06 EST 2010 | bagindia
we are facing vision error problem after running the machine for half an hour.Cause is x-axis motor % is changing & also motion is little harder compared with Y-axis
Electronics Forum | Tue Feb 12 11:26:31 EST 2019 | aldrich17
Does anyone have any info. on an "E869" error code on a Phillips Topaz X SMT machine. Error screen shows "Nozzle down limit sensor is off in A-table YV100X:N2323 YV100XT:n2223 Please check sensor and remove to the cause of this sensor being off.