Electronics Forum | Wed Sep 16 14:04:33 EDT 2015 | adventurelights
Hi guys, Recently got an error message when initiating hardware on a Mydata TP9-UFP. Message is: Theta/2: Lower end point not repeatable. Reinitiating fails at message. Haven't seen this message before. Any idea what it could be as production is hal
Electronics Forum | Sat Sep 26 00:53:54 EDT 2015 | padawanlinuxero
Hi guys, > > Recently got an error message when > initiating hardware on a Mydata TP9-UFP. Message > is: Theta/2: Lower end point not repeatable. > Reinitiating fails at message. Haven't seen this > message before. Any idea what it could be as
Electronics Forum | Fri Sep 18 13:11:38 EDT 2015 | dyoungquist
We used to run a TP9-2 but upgraded to the MY series about 5 years ago..... Encoder going bad is a likely possibility, especially on a machine that old. I can't say for sure that is your problem but we did have to replace an encoder on our TP9 (I
Electronics Forum | Tue May 07 13:41:36 EDT 2013 | cyber_wolf
MOVFI is a theta error there are about 10 things that can cause it. Start with making sure you do not have an acceleration set to lowest while the others are at high or highest in the package data. Next look at ribbon cables...
Electronics Forum | Tue May 07 13:51:51 EDT 2013 | shankar2013
acceleration is set to lowest. Ribbon cables were replaced, theta motor replaced. I also see a message pop up just after F-MOT1-26/156:MOVFI: MOTOR TIMEOUT / F-AXIS-182:C-AXIS NOT properly out when expected / 25v reads 3V. Now all these messages
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Tue Jul 10 11:36:22 EDT 2007 | dyoungquist
Hi SMT Frog We are using an upgraded Mydata TP9-1 system to place 0402s. We do an electrical test plus mechanical centering and use the C14 tool. A few things we have observed/learned: 1) Is the machine not picking the part up out of the tape? Po
1 |