Electronics Forum | Tue Jun 25 21:13:10 EDT 2024 | jeremyc
I also happen to be running into this issue. A PCB we're trying to program has a width larger than the max board width. On our O2i, it says 12.992in is the max board width. HOWEVER the tech specs of Dek Horizon O2i advertise a max print area of 508m
Electronics Forum | Mon Jul 16 12:19:00 EDT 2012 | jorge_quijano
Does anyone have experience with very large PCBs at Solder Paste inpection? our largest board is 32" x 22", it is a 0.250" thick and I was wondering if there is an Inline SPI for such dimensions. Currently I have a benchtop height measurement device
Electronics Forum | Wed May 19 20:24:09 EDT 2021 | kumarb
Thank you Michal. Very much appreciated. We are thinking along the same lines. However, we are being very afraid to even cut the official wire ties that are securing the head 1 and head 2 wiring. We have a new VAC2 solenoid in transit that will arr
Electronics Forum | Wed May 06 20:52:26 EDT 2015 | arbpkevin
I have been using my topaz X for about 4 years now and I feel that I am fairly knowledgeable about it, at least the functions of it that I use... I am trying to use the LCS to place some qfp chips on a new product and I have set the whole thing up t
Electronics Forum | Wed May 13 10:34:57 EDT 2015 | squeekypigeon
If memory serves me right, if you are test picking a component which will be served to the machine via an LCS the 'pick position' will automatically set itself to feeder slot 1. If you change this to something more central (I used to use location 4
Electronics Forum | Wed May 13 12:39:25 EDT 2015 | arbpkevin
Ahh, yes. Just about the same time you replied someone else I asked said the same thing! I didn't realize that you had to put the part on by hand for the vision test. In the book it says to leave the feeder position set to the default setting. Fu
Electronics Forum | Thu Mar 17 09:56:34 EST 2005 | jmedernach
Tx, Your spec limit is the point at which you expect to see a failure. In other words, what is the probability that you'll see a short when you have .008" of solder paste? What is the probability that you'll see an open if you have .004" of solder
Electronics Forum | Mon Jan 08 19:52:14 EST 2007 | fastek
A soft limit error is an error due to trying to drive the head outside it's mechanical limits. Check your X-axis program data for this part.
Electronics Forum | Mon Oct 17 13:02:28 EDT 2016 | tdemon69
i have a MPM2000 now giving me 0 - hardware limit warnings..let me start off by saying that is was giving me x axis limit problems, so i replaced the x card with diff card. set all the switch and jumpers to x card , then i got 0- hardware . so then
Electronics Forum | Mon Dec 26 12:21:15 EST 2005 | davef
Sure, you can use X7R dielectric ceramic capacitors on mixed technology boards. You need to be aware of the limitations and design and control your process appropriately. Continuing: * BIG cracks show as hard failures * Small cracks show as a leakag
