Electronics Forum | Thu Jul 28 17:35:45 EDT 2016 | travishemen
We have similar machines and they will give errors like this if the adjustable sensor on the unload end is over the fixed or movable rail.
Electronics Forum | Thu Jul 28 15:43:48 EDT 2016 | ddina
Recently started setting up our GSM 4681A system, and one of the machines comes up with the message "WAITING FOR OUTPUT BOARD TRANSFER TO COMPLETE" after the Zeroing process has been started. Machine has all the defaults set, two SMEMA connected univ
Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina
I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the
Electronics Forum | Thu Oct 29 13:55:57 EDT 2015 | edgeflex
Hi, Since we change the small best of the head carriage, the head is not going to the right positions (paste/front/rear). I could not even make a pressure test. Anyway I don't have any error message. Does somebody knows something about this and ho
Electronics Forum | Wed Feb 13 18:13:58 EST 2019 | slthomas
I'm trying to visualize how that machine is laid out. Do they all rotate together, on a belt, so that there's only one sensor for the theta (R) home position?
Electronics Forum | Wed Feb 13 20:15:36 EST 2019 | aldrich17
They all rotate on the same belt but, 2 per head on heads 2, 4, 6, and 8. Placed on the front and back. Held by a bracket with 2 screws. But no matter how tight I set the screws upon adjustment they still get out of whack.
Electronics Forum | Sun Feb 03 09:36:29 EST 2019 | bobpan
Good job.... Sorry i didnt see this post...some of us were busy snow tubing over the weekend...haha. Many times over the years....the rubber belt inside the feeder will deposit material inside. Sometimes it ends up on the sensors and blocks the ligh
Electronics Forum | Mon Jul 28 17:13:28 EDT 2003 | Ryan Liao
Hello dear all: I have some problems with the CP642's vision process system . When the machine is working, sometimes the vision process system will appearance the error message. Error code :��1CA0A007�� Element code: FFFF Segment code: 0000 This s
Electronics Forum | Mon Nov 21 21:46:49 EST 2011 | supse
Thanks Phil But the belt and spring has been changed recently. Unfortunatly we couldn't wait any longer for a solution, so we had to go for a change of the hydra-unit. This seems to have solved the matter, but I had hoped for a less expensive solutio
Electronics Forum | Wed Nov 16 18:20:39 EST 2011 | dontfeedphils
According to the message guide it just says that it's a error telling you to initiate the Hydra Theta axis. I suppose the encoder for the hydra theta motor could be losing count and causing it to need to be re-initiated, or it could be something to
winsouce.jpg)