Electronics Forum | Thu Feb 02 13:22:58 EST 2017 | jluiscp10
Hi. We Recently adquired a used machine universal GSM2, (product tree #46368504 L524), we need the operation, programming, platform operation, PTF basic machine operation manuals. Could you help me with this? Thanks
Electronics Forum | Thu Feb 02 17:35:03 EST 2017 | dilogic
You can register your machine with Universal Instruments for very reasonable fee (I paid ~500$) and get access to their web-based support. Well worth the money. Also, you will be able to order spares, which you will certainly need...
Electronics Forum | Sat Oct 22 16:39:24 EDT 2022 | ttheis
We have mid-90's GSM's and we have had to trick the machine in some cases like this by making some of the rail area into board area.
Electronics Forum | Fri Oct 28 07:57:31 EDT 2022 | poly
I'd be happy with it just checking if all the pads for placement are on the board. The software (GSM) seems to complain if any of the part is off the board. I got around it by just making the board larger. I'd also like it if it just had a button for
Electronics Forum | Tue Oct 18 07:02:47 EDT 2022 | poly
The product editor complains if I have a part that overhangs the edge of the board. Any hints on how to fix this? Set the "board" size bigger than the actual board and the use an offset to make it in the right place? Or is there a better way to say t
Electronics Forum | Thu Oct 27 13:46:36 EDT 2022 | proceng1
I concur with what Tom said. Sometimes you have to trick the machine. Without seeing your board, I can't offer any specific advice. And I am not familiar with your machine, but we run SAMSUNG machines and between those and several different MPM Pr
Electronics Forum | Wed Oct 26 22:39:01 EDT 2022 | sarason
This is not really a bug. The logic is this if you place a component beyond the edge of the board, it should falloff! So instead on having a very complex algorithm to work out component centres and then make a judgement as to whether the connector is
Electronics Forum | Fri Oct 28 13:48:30 EDT 2022 | proceng1
Well, I'm not sure about the "Trust me" button. I assume you can't tell it the part is smaller than it is because then vision won't accept it. I often add 10mm or so in X direction. In fact, when I measure the board, I just round the X up, becaus
Electronics Forum | Fri Oct 28 14:09:39 EDT 2022 | ttheis
Allowing a part to go over the board boundaries can cause collisions when boards are nested. The software on these machines has limitations but it is plenty capable and rooted in preventing physical damage to the machine. Once you are familiar with t
Electronics Forum | Tue Nov 01 18:33:10 EDT 2022 | griinder
I assume you are programming with DPO? I am using a Fuzion, so it may be a bit different. In "Environment Settings" (The little PC icon in the DPO start bar) under the products tab I am able to change the product load options to "warning" instead of
.gif)
winsouce.jpg)
