Electronics Forum | Wed Aug 31 13:02:36 EDT 2016 | cyber_wolf
Some of the MPM machines have a SMEMA configuration in the software. Not sure about the UP500.
Electronics Forum | Wed Aug 31 17:12:23 EDT 2016 | ttheis
Yeah, it's set to use SMEMA for down line. I have the conveyor conected to downline fmi on up500 (right side of machine,) but the Upline Ready light is activated on the up500 when the conveyor is ready and not the downline like I would expect to see.
Electronics Forum | Wed Aug 31 17:39:44 EDT 2016 | dekhead
2 on SMEMA end of cable) does it indicate downline available?
Electronics Forum | Fri Jan 17 03:23:14 EST 2014 | aemery
A UP500 Wow! I did work on one last year. Most left out there are labeled QUAD AVX500's, then Speedline bought Sigmaprint and it became a UP500. But you get the MPM sigpro software with the Speedline machine; they didn't build to many. It was used
Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis
I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe
Electronics Forum | Fri Aug 20 18:52:40 EDT 1999 | Gary Kemp
Would like to find out if the nozzles used with the Zevatech FS730 and FM740 component placers are repairable. In other words, is there a way to get around having to cough up $500.00 per nozzle when one gets damaged? Any insight would be greatly ap
Electronics Forum | Tue Oct 07 15:45:33 EDT 2003 | adlsmt
I believe NEA still sells new UP500's for around $45K. I think MPM dumped them all there and pays them as they sell. Is it worth looking at if the software is upgraded? I had the general opinion that the hardware was not so hot.
Electronics Forum | Wed Sep 07 07:53:16 EDT 2016 | ttheis
Looks like I've got to reconfigure the fmi connections. Only pins 1 & 2 populated and when I jump the fownline pins the upline ready signal is activated. I'll reference the diagram and setup the connections for smema.
Electronics Forum | Thu Dec 01 13:35:21 EST 2016 | ttheis
I decided to replace the psu with three din supplies since it was a repeatable issue with the 5v rail. Machine is back in operation now with no signs of problems.
.gif)
