Electronics Forum | Fri Oct 13 13:44:03 EDT 2000 | Mike McMonagle
You can achieve a wide range of dot heights when stencil printing by using a polyimide stencil along with a .040 snapoff. Loctite has a system for this that they call Varidot, by varying the size of the apertures in combination with the .040 snapoff
Electronics Forum | Fri Oct 22 06:19:42 EDT 1999 | TNT
Ron, if I am reading this correctly the 20mil parts are not having problems on a 6mil stencil. If you increase the entire thickness of the stencil to 8mils, there should not be any issues with the 20mil components. The supports you are using could p
Electronics Forum | Thu Jun 24 10:11:33 EDT 1999 | Dave F
| Dear guys, | | I have some problem on assembling micro-BGA with solder paste (63/37). The micro-BGA we assmeble is 0.75mm pitch and with 45 pin (solder bump is 96.5/3.5Ag). The stencil is a laser-cut stencil with 5 mil thickness. We are now usin
Electronics Forum | Thu Jun 24 16:19:46 EDT 1999 | Kennyv
| | Dear guys, | | | | I have some problem on assembling micro-BGA with solder paste (63/37). The micro-BGA we assmeble is 0.75mm pitch and with 45 pin (solder bump is 96.5/3.5Ag). The stencil is a laser-cut stencil with 5 mil thickness. We are no
Electronics Forum | Fri Nov 12 11:07:08 EST 2004 | valuems
Hello Terry We have found that the best angle for metal blades is 37 to 45 degrees. Metal blades won't enter the stencil opening, rubber does. Metal blades are with out question the best way to print. If you go over 45 degress the blades will leav
Electronics Forum | Mon Oct 31 14:46:54 EST 2005 | valuems
Hello Did you just buy this machine on the used market? There is a possibility that the stencil is not height on all 4 corners ( from the center nest assembly. I don't under stand " the under stencil wiper is not working correctly". This is about
Electronics Forum | Wed Nov 02 01:53:41 EST 2005 | pavel_murtishev
Hello, Thank you for answer. We are using second hand machine. What do you mean saying that �stencil is not height on all 4 corners�? Does it have some inclination between corners? I mean that three corners of stencil are matching with PCB fine and
Electronics Forum | Wed Nov 25 01:00:54 EST 2009 | henry_usa_stencils
The design of the opening apertures for the glue stencil and the metal thickness.Its is very important. The Engineer of the stencils supplier have to look into the height of the components and the gap of the 2 leg(pads)and give the assemly house an s
Electronics Forum | Mon May 20 16:15:48 EDT 2019 | davef
Resources are: * IPC-7525A - Stencil Design Guidelines, 3.5.2 Step-Up Stencil This type stencil is useful when it is desirable to print thicker solder paste in a small portion of the stencil. An example would be a ceramic BGA where it is necessary t
Electronics Forum | Tue Jan 04 17:54:37 EST 2000 | Josue Jacquez
Does somebody knows what should be the max acceptable height for the paste printing process using a 6 mils stencil?? I'll appreciate your help!!