Electronics Forum | Wed Sep 12 02:48:26 EDT 2007 | snipper53
i am using LPKF Contac III machine for through hole plating . the chemical is Activator310 from LPKF . i want to know the composition of this chemical or the alternate as it is been provided at very high price . i hope someone will help me
Electronics Forum | Sun Oct 09 01:11:34 EDT 2005 | vev
There is a stencil cutting machine in the industry which utilizes a water jet to deliver a Laser beam for cutting stencils. There are no machines of this type in the states. The quality is no better than a Laser cut stencil using a good Laser System.
Electronics Forum | Wed Nov 11 16:42:06 EST 2009 | isd_jwendell
For a manual printer, I like using this one: http://www.lpkf.com/products/rapid-pcb-prototyping/smd-assembly/solder-paste-printing/smt-solder-paste-printer-metal-stencils.htm
Electronics Forum | Fri Nov 13 11:02:46 EST 2009 | isd_jwendell
I use the LPKF model S. Operator uses a urethane(?) squeegee. Pressure and speed are controlled by the operator, which hasn't been a problem for me. The only problem I had was that I would forget to raise the PCB before I would start to squeegee the
Electronics Forum | Tue Sep 12 16:27:20 EDT 2006 | EK
I'm in the market, also, but vasilating over cost vs performance. I've also used both. In general, the LPKFs have more bells and wistles. On the LPKF S62, I love the tool magazine, and vacuum table. And, the fiducial recognition camera is great o
Electronics Forum | Wed Jun 29 11:09:26 EDT 2011 | swag
That is all we have ever used ("Zelflex" by LPKF). They work great. We have 300+ stencils stored in print drawers, probably 3'x3'x5' area. The stencils are also cheaper by more than 1/2 from our supplier. The only stencils we have in permanent fra
Electronics Forum | Mon Jul 11 07:49:06 EDT 2005 | davef
Approaches are: * PCDATAK sells [through distributors and hobbist sites] inexpensive layout software and plastic sheets that you run through a copier and then use to image the traces on the bare board. Since you have the software, all you need is th
Electronics Forum | Fri Aug 06 10:06:34 EDT 1999 | Peter Brant
| | | I need to find quality benchtop develop, strip, & etch equipment. | | | Any ideas? | | try LPKF in Beaverton, Or. 503/634-0604 or the link below. I haven't used their eq so this is not an endorsement | | John Thorup | | let's try that link a
Electronics Forum | Tue Oct 10 18:17:13 EDT 2006 | Dave from Ohio
We currently use both machines side by side in our lab now and LPKF is by far the better machine. Both are comparable systems to each other but the T-Tech machine always seems to have problems of some sort and their tech support department isn�t ve
Electronics Forum | Thu Nov 12 20:37:41 EST 2009 | isd_jwendell
I used a clam-shell type for years before switching to the LPKF. The ZelPrint LT300 looks a lot like the LPKF one. I prefer the LPKF or ZelPrint style because they are capable of getting better (more accurate and more consistent) prints when compared