Electronics Forum | Fri May 27 13:20:06 EDT 2016 | elton111
how are you. I have a problem with a table that the issue errori topaz. The issue is the message "Bring back component." a problem with the pick up parts vacum setting level is 100 and the current 111 with vacum head is 6. Can u tell me how to Calibr
Electronics Forum | Wed Sep 23 18:20:48 EDT 1998 | Alvaro Carrillo
Hy everybody. Somebody know about a IC's storage with controled temperature, vacum for special IC. I apreciate any information about, Where can I buy, whatever. thanks AC
Electronics Forum | Wed Mar 31 01:14:49 EST 2004 | Peter -CP40
Eric, You should be able to monitor the pressure of your nozzles by selecting: Diagnostics / Vacume check, depending on the type of machine you are running. When you cover the end of the nozzle, you should get a reading of about 500. This means it i
Electronics Forum | Thu Apr 08 10:54:16 EDT 2004 | mrmaint
We typically store the tubes straight up and down. This seemed to help with the air pocket problem. Did not solve it 100 percent. best bet is still vacum.
Electronics Forum | Thu May 21 02:11:12 EDT 2015 | Pawel
Hi everyone, I have a lot off failed inspections on SPI with contaminated PCB (hair, speck of dirt, fiber...). Do you know any vacum tool which can clean board before screen printer?
Electronics Forum | Wed Jul 24 12:09:29 EDT 2002 | deonnc
Hey guys, Anyone out there have any luck finding after-market Philips Topaz vacum ejectors and air valves. I am looking for a source that may supply these. I tried the manufacturer directly but Philips has a proprietary design with Koganei which wil
Electronics Forum | Fri Jul 06 10:45:02 EDT 2012 | ashworth14
In relation to question 2 the vacume on them is quite sensitive so as long as you bring it down slowly the component is almost sucked up off the PCB so you don't have to actually press it down on the the component, and i have never experienced any so
| 1 |
winsouce.jpg)