Electronics Forum | Fri May 14 16:49:17 EDT 2021 | winston_one
Agree with WiIIR and also can recommend to play with vaccum pump RPM . Slower vacuum increasing have help me to resolve one problem caused by the vacuum (it was solder splash from BGA balls, but the reason can be similar to your case). Also check i
Electronics Forum | Wed Sep 04 14:12:26 EDT 2019 | bobpan
It sounds like the vac-verify is not working. There is a command on the hht to turn it off. When turning off your hht will show either 'idle' or enter command' without the V showing anymore. Maybe try the cntrl and vacuum or shift and vacuum. If its
Electronics Forum | Thu Sep 05 07:14:16 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the suggestions. Sorry I didn't reply yesterday as I'd gone home - I'm in the UK, so I'm guessing there's a time difference. Okay, I found the control to turn off the vacuum verify - it's SHIFT - SWITCH/VERIFY. Makes no di
Electronics Forum | Wed Sep 04 09:47:41 EDT 2019 | smrsteve
Hello All, I've just bought a Quad 4c pick & place machine. It's so close to actually building boards, but just doesn't quite get there. I was wondering if there's somebody out there with experience of these machines that might be able to help...?
Electronics Forum | Fri Oct 13 19:01:46 EDT 2023 | crystalw4280
I have an old Juki 2060 The electors were replaced on some heads that were disabled. Now we are showing some of the same errors with those heads. Does anyone have any suggestions for possible cause that would make this happen again. Another warning
Electronics Forum | Tue Oct 24 19:09:12 EDT 2023 | sarason
Possibly blocked air lines did you check air pressure? Also drivers on the relevant boards. or simply damage in the flexible wiring harness( a nightmare) sarason
Electronics Forum | Tue Mar 05 09:11:11 EST 2019 | slayervv
The conveyor on our Topaz runs for about a second then stops. Turning on conveyor manually does the same thing. While conveyor is turned on manually, disconnecting and reconnecting 208AC at connection board starts the conveyor for a second then it
Electronics Forum | Tue Sep 20 14:03:53 EDT 2011 | russw
We don't have the equipment to check specific gravity, we just assume what's on the bottle is correct and we've never had a problem. The stone sits in an open chamber, so there really isn't any pressure to check. When we vary the air flow, the foam
Electronics Forum | Wed Sep 04 13:32:22 EDT 2019 | bobpan
Try these things: 1. Do a function 30....your nozzle height should consistently be around 200 +/-20....but whatever number it does find it shouldn't change. (with nozzle on) 2. Most times its the z-bellows....an old z bellows that has a worn out spri
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go